Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Robin America EX30
Summary of Contents for Robin America EX30
- Page 1 MODEL EX30D 2ZZ9990095...
- Page 3 WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A.
- Page 4 FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE This emission warranty is applicable in all States, except the State of California. Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein “ROBIN AMERICA”) warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein “engine”) has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S.
-
Page 5: Limited Warranty
CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein “FUJI”) are pleased to explain the emission control system warranty on your 2005 and later Small Off-Road engine (herein "engine"). In California, new engine must be designed, built and equipped to meet the State's stringent anti-smog standards. - Page 6 When warranty repair is needed, the engine must be brought to an authorized service dealer or warranty station’s place of business during normal business hours. In all cases, a reasonable time, not to exceed 30 days, must be allowed for the warranty repair to be completed after the engine is received by the authorized service dealer or warranty station.
-
Page 7: Table Of Contents
Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Keep this owner’s manual at hand, so that you can refer to it at any time. -
Page 8: Safety Precautions
1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. CAUTION “CAUTION”... - Page 9 Do not touch the spark plug and ignition cable when starting and operating the engine. ■ Never make adjustments on the machinery while it is connected to the engine, without ■ first removing the ignition cable from the spark plug. Turning the crankshaft by hand during adjusting or cleaning might start the engine, and cause serious injury to the operator.
-
Page 10: Components
SYMBOLS l i o 2. COMPONENTS (See Fig. 1 1 1 1 1 ) NOTE Please refer to the illustrations on the back page of the front cover or back cover for Fig. 1 1 1 1 1 to 6 6 6 6 6 indicated in the sentence. q SPARK PLUG w DUCT e STARTER HANDLE... -
Page 11: Pre-Operation Checks
3. PRE-OPERATION CHECKS NOTE Engine shipped from our factory is without oil. Before starting engine, fill with oil. Do not over-fill. CHECK ENGINE OIL (See Fig. 2 2 2 2 2 ) Before checking or refilling engine oil, be sure the engine is located on stable, level surface and stopped. -
Page 12: Operating Your Engine
Flywheel WIRING DIAGRAM (ELECTRIC STARTER MODELS) Spark plug Black Ignition coil Magneto Charge coil Diode rectifier LA306 EX30 To Key switch (B) To Diode rectifier LA108 LA408 To Key switch (ST) Electric starter To Battery Electric starter Optional hardware shown by dotted lines. -
Page 13: Maintenance
※ STOPPING ENGINE WITH THE FUEL COCK Close the fuel cock and wait for a while until the engine stops. Avoid to let the fuel remain in the carburator over long periods, or the passages of the carburator may become clogged with impurities, and malfunctions may result. -
Page 14: Check Battery
3. INSPECTING THE SPARK PLUG (See Fig.5 5 5 5 5 -w w w w w ) (1) Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush. (2) Check electrode gap. The gap should be 0.6 mm to 0.7 mm (0.02 inch.-0.03 inch.). -
Page 15: Preparations For Storage
7. PREPATIONS FOR STORAGE 1. DISCHARGE FUEL (See Fig.6 6 6 6 6 ) WARNING Flame Prohibited If you do not use the engine more than 1 month, discharge fuel to prevent gum in the fuel system and carburetor parts. Remove the fuel cup, place it over a container and open ■... -
Page 16: Specifications
10. SPECIFICATIONS MODEL Type Displacement mL (cc) kW/rpm Continuous Output (HP/rpm) kW/rpm Maximum Output (HP/rpm) Direction of Rotation Lubricant Oil Capacity Liter Fuel Spark Plug Starting System Dry Weight Dimensions (L x W x H) mm Valve Clearance (Intake and Exhaust) Emissions Durability Period (California only) EX30D...