Toshiba Satellite P25 Series Resource Manual page 26

26
Setting up your computer and getting started
Connecting a printer
To make the connection, you need a suitable USB cable,
which may come with your printer. Otherwise, you can
purchase one from a computer or electronics store.
Installing additional memory (optional)
Your computer comes with enough memory to run most of
today's popular applications. You may want to increase the
computer's memory if you use complex software or process
large amounts of data.
There are two memory slots. Your system may have both
slots occupied.
You need a standard Phillips no. 1 screwdriver to install a
memory module.
If the computer is on, begin at step 1, otherwise, skip to step
3.
1 Turn off the computer via the Start menu.
The operating system turns off the computer.
2 Unplug and remove any cables connected to the
computer.
3 Remove the battery.
4 Close the display panel and turn the computer upside
down to locate the expansion memory slot cover.
Follow the manufacturer's instructions for connecting a USB printer
to your computer.
Before you install or remove a memory module, turn off the computer
using the Start menu. If you install or remove a memory module
while the computer is in Standby or Hibernation mode, data will be
lost.
To avoid damaging the computer's screws, use a standard Phillips
no. 1 screwdriver that is in good condition.
Do not install or remove a memory module while the DVD-ROM
drive power is on.