Table of Contents
Advertisement
5. TRANSPORT, UNPACKING AND ASSEMBLY
5.1 Transport and unpacking
The machine is not assembled due to transport.
Remove the feeder from the packaging and place
on a flat surface. Check for any apparent transport
damages, these could damage the machine or your
health.
5.2 Assembly
We recommend to greasing the metal parts before
assembly.
5.2.1 Fastening to a machine
- Mounting the base. The feeder is supplied with a 1:1
template that facilitates the mounting of the feeder
onto a base.
1. Unpack the feeder base and adjust it according to
the mounting template.
pic.2
F
F
2. Prepare 4 bolts and spring washers (not included).
Bolt size - M10, length = feeder base (thickness) +
table top (thickness)
3. Select position of the base to avoid ribbing on the
bottom of the table.
5.2.2. Assembly
- Fasten the base of the feeder to the table top using
four M12 bolts, place the stand into the base. Screw
the handle into the lever using the nut under the
handle.
Insert the arm (1, pic.5) into the height-adjustable
(Obr. 4)
holder. Mount the control wheel 4 so that the pinion
2 fits into the teeth of the feeding comb. Screw the
locking screw 3 from the bottom side and tighten
with a contra nut against the screw.(pic.5) Insert the
scale ring (R, pic.6) on the arm of the feeder and slide
further away from the edge. Insert the cable into the
www.igmtools.com
BORE
10.3-10.5mm
TAP M12 x P1.75
BORE
8.5-8.7mm
TAP M10 x P1.5
UNIVERSAL BORING TEMPLATE
（ １ ： １
SELF-ADHESIVE
）
MATCH TEMPLATE TO YOUR BASE
１.
。
CUT OFF THE EXCESS PORTION
２.
。
３.
CLEAN MOUNTING LOCATION
。
Heavy Duty
SCREWS NOT INCLUDED
4-M12
pic.3
(Obr. 5)
4
opening on the side of the arm (8.1, pic.7). Insert the
cable into the sleeve up to the double insulation.
It's necessary to take the cable apart from the
terminal plate - Only an electrician with a proper
permission is allowed to do that. Mount the joint
end and so far tighten only with one screw.
De-grease the surface with rubbing alcohol and put
R
pic
(Obr.
on the sticker with a scale (S, pic.7 and 8).
7)
Mount the handle (1, pic.9) into the feeder but
don't tighten too much, it should rotate. Mount the
positioning joint onto the pin on the feeder and
screw in using the locking lever. (pic.10)
Place the feeder on your workbench. Move the joint
end towards the pin screwed into the arm. Mount
on the pin and tighten the locking lever (1, pic.11).
Tighten the screws on the joint ending (2, pic.7).
pic.4
.8
pic
(Obr. 9)
.10
pic
-5-
Operating instructions EN
2
3
(Obr. 6)
M4
.6
9
pic.
1
2
.11
pic
1
.5
pic
S
2
8.1
(Obr. 8)
.7
pic
(Obr. 10)
1
Advertisement
Table of Contents
