Let's Go Aero B00451 Product Manual

ASSEMBLY, INSTALLATION, AND OPERATION INSTRUCTIONS

NOTICE: All Manual information is subject to change without notice. Revised editions

will be available for free download at LetsGoAero.com. Manual information is considered

factual until made obsolete by a revised version.

Follow this QR-Code or visit

LetsGoAero.com/manuals to check for an updated version:

For More Information & Accessories, Visit our Website - www.LetsGoAero.com

For Technical Support & Product Questions Contact Us at 877-464-2376 or 719- 630-3800

WCB00451-051021Rev

PRODUCT MANUAL

Rated for 40 lbs per Bicycle.

QTY. DESCRIPTION

CRADLE HOUSING

UPPER WHEEL CRADLE

LOWER WHEEL CRADLE

RUBBER STRAPS

Email: SUPPORT@LETSGOAERO.COM

Page 1 of 3

Replacement Wheel Cradle Kit

Wheel cradles and straps for one (1) bike

PARTS

Part No. B00451

PATENTS PROTECTED

Revision Date: 05/10/21

Table of Contents

Do you have a question about the B00451 and is the answer not in the manual?

Page 1 Replacement Wheel Cradle Kit Wheel cradles and straps for one (1) bike Part No. B00451 PRODUCT MANUAL ASSEMBLY, INSTALLATION, AND OPERATION INSTRUCTIONS Rated for 40 lbs per Bicycle. PARTS QTY. DESCRIPTION CRADLE HOUSING UPPER WHEEL CRADLE LOWER WHEEL CRADLE RUBBER STRAPS NOTICE: All Manual information is subject to change without notice.
Page 2 STEP 1: Turn the handles on each Cradle Housing [A] to loosen their grip. [Fg. 1] Slide one Cradle Housing [A] above the foam bumpers and one Cradle Housings below the foam bumpers. NOTE: The Knobs located on each Cradle Housing [A] MUST rest along the same sides as the connection hole located at the bottom of the Wing.
Page 3 STEP 4: In the same manor as before, pull out the Knobs located on [Fg. 6] the Cradle Housing [A] installed below the foam bumpers on each Wing and insert a Lower Wheel Cradle [C] with Rubber Strap [D] facing as shown. [Fg. 6] Perform a small pull on the Lower Wheel Cradle [C] to ensure the knob is fully seated and the Cradle has been secured.