Character Code Table - Star Micronics NP-215 Specifications

Kiosk module printer

Hide thumbs

Table Of Contents

Table of Contents

20) Panel switch enable/disable:<< ESC c 5 n >>

Code

Changes the FEED switch valid or invalid.

* "n" is only valid for LSB(b0)

* "n" bit has a following meanings

21) Print and "n" line feed:<< ESC d n >>

Code

Prints the data in the print buffer and feeds paper by "n" lines.

* Beginning of a line is a print start position.

* If there is print data remained, line feed is activated for the same height of character.

22) Character code table select:<< ESC t n >>

Code

Selects either Japan code table or non-Japan code table.

Explanation : "n" value has following meaning.

n(Hex)

The default value of "n" is [S2-2] for DIP SW.

23) Printer status transmission

Code

Sends current printer status

* Status to be transmitted consist of 1 byte and the content is explained in the chart

below.

bit

* Make sure that command is issued before transmission of print data.

(commands are stored in the input buffer and executed sequentially)

* Reception is available except in the buffer full status.

* The commands above are valid only for serial interface.

* Regarding DTR/DSR control, only one byte is transmitted after confirmation that the

host is able to receive data, that is DSR signal is in SPACE status. For XON/OFF

control, one byte is transmitted without confirmation of DSR signal status.

* For DTR/DSR control, if host is not in a receivable status, it waits until host can receive

data.

24) Inverted character set and reset

: [1B ] h + [63] h + [35] h + n

enable FEED switch

disable FEED switch

Default value of "n" is [00]h.

: [1B] h + [64] h + n

: [1B] h + [74]h + n