Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Haas Automation Manuals
  4. Industrial Equipment
  5. OFFICE MILL
  6. Operator and installation manual

Haas Automation OFFICE MILL Operator And Installation Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
OFFICE MILL
OPERATOR'S ADDENDUM
96-0198 Rev V
March 2012
© 2012 Haas Automation, Inc.

Advertisement

loading

Related Manuals for Haas Automation OFFICE MILL

Summary of Contents for Haas Automation OFFICE MILL

  • Page 1 OFFICE MILL OPERATOR’S ADDENDUM 96-0198 Rev V March 2012 © 2012 Haas Automation, Inc.

  • Page 3: Installation

    Installation NOTE: Use these installation recommendations with those in the Vertical Mill Reference Manual. Information supplied here is given speciically for the Ofice Mill. The following steps are necessary to install an Ofice Mill. 1. Unwrap the shipping material and lift the machine from the pallet. 2.
  • Page 4 Using the Optional Caster Kit 1. Raise the leveling screws high enough to remove the leveling pads. This lowers the Ofice Mill onto the wheels. 2. Carefully move the mill to its new position. 3. Put the leveling pads back under the leveling screws and raise the mill to a position where all its weight is off the wheels.
  • Page 5 3. Open the doors at the front of the machine base. Remove the bolt that attaches the coolant tank shipping bracket and remove the bracket. Reinstall the bolt. Cable Carrier Shipping Bracket Coolant Tank Shipping Bracket Level the Ofice Mill NOTE: Refer to the Vertical Mill Reference Manual for machine leveling instructions.
  • Page 6 The Ofice Mill runs on single-phase power. It has a transformer in the control that con- nects to voltage that can range from 195V to 254V. 1. Measure voltage at the main circuit breaker and connect the main power cable to the appropriate tap on the transformer (taps available are 195-213V, 214-225V, and 226-254V).
  • Page 7 Spindle Operating Guidelines • Check the pullstud torque before the pullstud is loaded into the spindle. • Roughing operations should use 3/8" diameter or smaller tools. • Roughing operations should be at 10,000 rpm or higher. • Roughing depth of cut should be 20% or less of tool diameter. •...

  • Page 8: Operation

    T-Slot. Also, the TR110 rotary table may only be mounted with the length of the unit parallel to the X-axis of the mill. Office Mill with HRT110 Rotary Table Office Mill with TR110 Rotary Table The rotary table can be mounted in other T-slots or in other orientations (HRT);...