Table of Contents
Advertisement
Fig. 1
Number
1
2
3
4
5
6
7
8
Do NOT install the detector:
• Near the floor
• Near large metal structures
• Within 1 metre from power or gas lines
• Near electronic or radio equipment
• On moveable elements
• Upside down
Installation
1. Open the casing by loosening the screw and then removing the cover.
2. Remove the PCB from the housing: Pull the PCB carefully away from
the plastic clamps.
Name
LED
Screw
Battery
Potentiometer
Tamper protection, lid
LED – calibration mode
Tamper protection, wall
Jumper contacts A–D
Advertisement
Table of Contents
