Garmin LIVESCOPE PLUS Installation Instructions Manual
Garmin LIVESCOPE PLUS Installation Instructions Manual

Garmin LIVESCOPE PLUS Installation Instructions Manual

Ice fishing kit

Advertisement

Quick Links

Important Safety Information
See the Important Safety and Product Information guide in the chartplotter or fishfinder product box for product
warnings and other important information.
To obtain best performance and to avoid possible damage, you must install this mount using these instructions.
Read all installation instructions before proceeding with the installation. If you experience difficulty during the
installation, go to
support.garmin.com
Battery Warnings
The Garmin
device uses a user-replaceable, sealed, lead-acid battery. If these guidelines are not followed, the
®
battery may experience a shortened life span or may present a risk of damage to the device, fire, chemical burn,
electrolyte leak, and/or bodily injury.
• Do not place the battery near objects that may cause sparks, flames, or heat.
• Do not incinerate the battery.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open battery. Avoid contact with internal acid. Contact
with internal acid may cause irritation or severe burns. Irritation may occur to the eyes, respiratory system,
and skin. Flush with water at once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
• Keep the battery away from children.
• Only replace the battery with the correct replacement battery. Using another battery presents a risk of fire or
explosion of the device or charger.
• Only use the included Garmin 12 Vdc charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in a high-temperature location, such as in the sun in an
unattended vehicle. To prevent damage, remove the device from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than recommended chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of the battery in accordance with applicable local
laws and regulations.
• When storing the battery for an extended time, store within the following temperature range: from 5° to 104°F
(from -15° to 40°C).
• Do not operate the battery outside of the following temperature range: from 5° to 122°F (from -15° to 50°C).
July 2022
LIVESCOPE
PLUS ICE FISHING KIT
INSTALLATION INSTRUCTIONS
for more information.
WARNING
WARNING
GUID-BAEE5DD3-334E-4376-BEED-554C6FEFB779 v1

Advertisement

Table of Contents
loading

Summary of Contents for Garmin LIVESCOPE PLUS

  • Page 1 • Only replace the battery with the correct replacement battery. Using another battery presents a risk of fire or explosion of the device or charger. • Only use the included Garmin 12 Vdc charger. • Do not charge the battery in an unventilated area.
  • Page 2: Charging The Battery

    Charging the Battery CAUTION Ensure that you connect the correct spade connector to the correct battery terminal. Damage to the battery or device, or bodily harm may occur if the device is improperly connected to the battery. You should always use the all-in-one cable to charge the battery. 1 Remove the battery terminal covers.
  • Page 3 Attaching the Bail Mount You need a Phillips screwdriver to attach the bail mount to the portable mount. 1 Align the chartplotter bail mount over the hole pattern that matches your bail mount, with the openings on the top of the bail mount facing the back of the base. 2 Secure the bail mount to the base using the four included 24 mm machine screws and the included washers, if you are installing a metal bail mount.
  • Page 4 Assembling the Garmin Ice Fishing Pole Mount You need a Phillips screwdriver to assemble the Garmin Ice Fishing Pole Mount. NOTICE Keep the transducer cable secure during installation. Damage to the transducer cable wire or the cable jacket can cause transducer failure.
  • Page 5 TIP: The top of the transducer must be below the bottom of the ice for best performance. To install the transducer on the Garmin Ice Fishing Pole Mount, you need the included hardware and hex wrench. 1 If the pole is equal to or less than 25 mm (1 in.) in diameter,...
  • Page 6 4 Place the transducer against the shaft-mount bracket, and secure it using the neoprene washer knob 5 Secure the transducer cable to the pole or other secure location, and route the cable to the GLS 10 sonar ™ module. 6 Connect the transducer cable to the XDCR port on the GLS 10 sonar module. TIP: To reduce electromagnetic interference, snap the ferrite bead (if included) onto the transducer cable near the connector to the GLS 10 sonar module.
  • Page 7 9 Place the mount base around the hole in the ice. 10 Rotate the handle to aim the transducer. Effective Forward and Down Range NOTE: Water conditions and bottom conditions affect the depth and range performance of the transducer. You should use caution and observe the water depth and range, especially when your unit is operating in manual range or depth mode.
  • Page 8 1 Install the mounting bracket but do not use the included adjustment knob (Installing the Transducer on the Garmin Ice Fishing Pole Mount, page 5). 2 Instead of using the knob, use the low-profile screw...
  • Page 9: Specifications

    Specifications Ice Fishing Bundle Specifications Battery type Sealed, lead acid, 12 Ah Up to 7 hr. NOTE: The actual battery life of a fully charged battery can vary based on the device Battery life used, backlight brightness, temperature the battery is operated and stored in, age of the battery, and depth of the water.
  • Page 10: Open Source Software License

    © 2022 Garmin Ltd. or its subsidiaries Garmin ® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. LiveScope ™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.

Table of Contents