Connections; Connecting The Ac Power Cord; Attaching The Ferrite Core (Pfm-42B2/42B2E Only); Connection Example - Sony PFM-42B1 Operating Instructions Manual

Connections

Connections

Connecting the AC Power Cord

1
Plug the AC power cord into the AC IN socket.
Then, attach the AC plug holder (supplied) to the
AC power cord.
AC IN socket
2
Slide the AC plug holder over the cord until it
connects to the AC IN socket cover.
To remove the AC power cord
After squeezing the AC plug holder and freeing it,
grasp the plug and pull out the AC power cord.
Attaching the ferrite core (PFM-
42B2/42B2E only)
1
Attach the ferrite cores to both ends of the AC
power cord and close the ferrite cores until they
click.
14
(GB)
2
3
AC power cord
AC plug holder

Connection Example

Before you start
AC IN socket
cover
• First make sure that the power to each piece of
equipment is turned off.
• Use connecting cables suitable for the equipment to
be connected.
• The cable connectors should be fully inserted into
the jacks. A loose connection may cause hum and
other noise.
• To disconnect the cable, pull it out by grasping the
plug. Never pull the cable itself.
• Refer to the instruction manual of the equipment to
be connected.
• Insert the plug securely into the AC IN socket.
• Use one of the two AC plug holders (supplied) that
will securely hold the AC plug.
Wind the stopper round the cord so that the ferrite
cores do not slide.
Tighten the stopper and cut the surplus.