Advertisement
Quick Links
Advertisement
Related Manuals for Congo Play MONKEY PLAYSYSTEM FORT
Summary of Contents for Congo Play MONKEY PLAYSYSTEM FORT
- Page 1 PACKACif 1 5HOWN MONKC:Y PlAY5Y5ffM fORI A55�MB� Y IN5fRUCflON5...
-
Page 3: Parts Identification
PARTS I DENTIFICATION WOOD COMPONENTS 1-------------------------7 QUANTITY DESCRIPTION ID LETTER NOTE: If you are assemblin package 2 and 4, you will not receive item. L __________ FORT DECKLADDE � SSEMB� _____ 4"x4"x96" - FORT UPRIGHT 4"x4"x96" - FORT UPRIGHT 2"x6"x93" - FORT GROUND BEAM •... - Page 5 PARTS I DENTIFICATION WOOD COMPONENTS cont. Q UANTITY DESCRIPTION ID LETTER 2"x4"x45" - WALL RAIL 2"x4"x20 ¾" - WALL RAIL I • 2"x4x12" - WALL RAIL 1 "x6"x45 ½" - FLOOR BOARD 3/s" - 1 "x6"x37 END FLOOR BOARD 1 "x6"x37 3/8" - ROCKWALL BOARD 1 "x4"x48"...
-
Page 6: Hardware Identification
HARDWARE IDENTIFICATION � --- I --- ---- 05/16" 5 1/2" HEX BOLTS (16) �- I - - - 05/16" 4-1/2" HEX BOLTS (6) ■ � ,___ I - - 05/16" 1-1/2" HEX BOLTS (2) 05/16" 1-3/4" HEX BOLTS (4) 05/16" 1-1/2"... - Page 7 HARDWARE IDENTIFICATION CONT. 01/4" x 3-1/2" RS S LAG S CREWS (5) 03/8" T-NUTS 05/16" T-NUTS 05/16" FLAT 03/8" FLAT (28) WASHERS (116) WASHERS (15) © � 05/16" SPLIT 01/4" T-NUTS 05/16" LOCK WASHERS (28) 01/4" FLAT (10) NUTS (2) WAS HERS (19) (8) L - BRACKET #20 STAR...
- Page 11 PHASE 3 FRAME ASSEMBLY - cont. TABLE 3 - PARTS AND HARDWARE STEP 1: Gather parts and hardware shown in table 3. It> LE'TTER DESCRIPTION FORT GROUND BEAM NOTE: An adult helper is required to stand SANDBOX BOAR!) phase 2 frame assemblies upright FLOOR CAPS and hold in place until phase 3 is complete.
- Page 13 FLOOR BOARDS AND FLOOR CAPS PHASE 5 ATTACHMENT TABLE 5 - PARTS AND HARDWARE II> I.ETTER DESCRIPTION STEP 1: Gather parts and hardware shown in table 5. FLOOR BOARDS STEP 2: Attach floor boards ' S' and end floor ENI> FLOOR BOARDS boards 'T' to floor joist 'I' and 'K' WALL RAn.5 with 2"...
- Page 15 PHASE 7 WALL SLATS ATTACHMENT TABLE 7 - PARTS AND HARDWARE If attaching tower, do not attach wall slat 'Z' II> I.ETTER DESCRIPTION to this end. WALL SLATS 1-5/8" DECK SCREWS STEP 1: Gather parts and hardware shown in table 7 STEP 2: Attach wall slats 'Z24' to wall rails 'J','R' &...
- Page 16 PHASE 8 WALL SLATS ATTACHMENT - cont. NOTE: ____ If attaching tower, do not attach wall slat 'Z" to this end. DETAIL - 7 lo/a" DECK SCREW 2" z--- STEP 1: Gather parts and hardware shown in table 8. STEP 2: Attach wall slats 'Z24' to wall rails 'P' with 1-5/8"...
- Page 17 TARP SUPPORT ASSEMBLY PHASE 9 "STOP IF ADDING WOOD ROOF" TABLE 9 - PARTS AND HARDWARE STEP 1: Gather parts and hardware shown in table 9. II> LETTER l>ESCRIPTION STEP 2: Attach tarp support 'N' to fort upright 'A' with ENI>...
- Page 18 PHASE 98 TARP SUPPORT ASSEMBLY TABLE 9 - PARTS AND HARDWARE ***Skip phase 9B through phase 11 if you have a wood roof It> LETTER DESCRIPTION upgrade*** TARP END CAPS #8 x 2" DECK SCREW STEP 1: Gather parts and hardware shown in table 9. STEP 2: Attach tarp end caps 'W' to end tarp support 'N' and 'MA' with 2"...
- Page 23 Addendum to the instructions: Please add this additional bracket during the installation of your Congo Play Set. This is for use with the A-Frame Square Bracket. Attach the bracket to the bolt with the safety nut provided. Then attach the Swing Beam with the RSS or Lag screw provided.
- Page 24 PHASE 14 A-FRAME and SWING BEAM ATTACHMENT TABLE 14 - PARTS AND HARDWARE STEP 1: Gather parts and hardware shown in table 14. II> LETTER l>ESCRIPTION STEP 2: Hammer 05/16" t-nut to a-frame leg A-FRAME UPRIGHT as shown. A-FRAME BRACE STEP 3: Attach a-frame leg to swing beam a-frame 05/16"...
- Page 27 PHASE 17 ROCKWALL ASSEMBLY TABLE 17 - PARTS AND HARDWARE STEP 1: Gather parts and hardware shown in table 17. II> LETTER DESCRIPTION ROCKWALL BOARDS STEP 2: Install 01/4" t-nuts into the backside FORT ANGLE BRACE/ROCKWALL SUPPORTS of each rockwall board 'U'. L-BRACKETS STEP 3: Attach rockwall rocks to rockwall boards 'U' ROCKWALL ROCKS...
Need help?
Do you have a question about the MONKEY PLAYSYSTEM FORT and is the answer not in the manual?
Questions and answers