Page 2
Product description The EZHold Lid Holder attaches to a microbioreactor, helps separate the lid from the microplate, and enables adding supplements or other components into wells without cross contaminating samples. Instructions for use Knob Clamp C.BIRD/S.NEST Lid Microplate Platform 2 | EZHold Instruction guide CYTENA BPS ...
Page 3
• Separation 1. Make sure the platform rises to its highest possible position by turning the knob clockwise until it is tight. 2. Place the plate/lid set onto the platform. Plate positioning grooves 3 | EZHold Instruction guide CYTENA BPS ...
Page 4
3. Push the plate/lid set forward into the EZHold until it is held tightly by the clamp. For C.BIRD lid, the two For S.NEST lid, the two air protruding ports on the top of ports must be faced inward the same side of the lid must be into the EZHold faced inward into the EZHold.
Page 5
4. Lower the platform by turning the knob counterclockwise. Hint To avoid contamination, cover the standard microplate lid before removing the plate. 5 | EZHold Instruction guide CYTENA BPS |...
Page 6
• Assembling 1. Place the plate onto the platform. Make sure the plate is tightly positioned on the platform. Push the plate forward to the very end 2. Raise the platform to the top by turning the knob clockwise; this ensures the plate is secured on top of the lid.
Need help?
Do you have a question about the CYTENA BPS EZHold AC0104 and is the answer not in the manual?
Questions and answers