Bottom Side Of The Braillenote Touch; Bluetooth; Wi-Fi; Setting Up - Humanware BrailleNote Touch Plus User Manual

1.3.7

Bottom Side of the BrailleNote Touch

A camera and two LED lights are located on the back side of the BrailleNote Touch. The camera is
located in the center top of the BrailleNote Touch, with the two led lights located closer to the edges on
the left and right side of the camera, inside circular hollow areas.
The battery compartment is also located on the back of the BrailleNote Touch, just below the camera
and led lights. You will feel it has a rectangular shape spanning almost the entire length of the tablet,
with a hollow area on the bottom side. On the left and right sides of this hollow area, somewhat closer
to the edges of your BrailleNote Touch, are two battery release latches. You can remove the battery of
your BrailleNote Touch by simply sliding these two latches outwards simultaneously.
1.3.8

Bluetooth

The BrailleNote Touch features an internal Bluetooth Interface.
1.3.9

Wi-Fi

The BrailleNote Touch features an internal Wi-Fi B/G/N interface, 2.4 - 5 GHz.
2

Setting Up

Press and hold the Power button. You will feel a quick vibration, and after 7 to 8 seconds, you will see
"Starting KeySoft" on the Braille display with a progress representation. A few moments after you first
boot your device, you will be welcomed with a language selection screen and an interaction Wizard that
will help you get started with your BrailleNote Touch. The Wizard will help you familiarize yourself with
the more common features of your BrailleNote Touch. Below are a few helpful commands you should
memorize that will help you use your tablet more efficiently. For a thorough list of commands, please
refer to the Command Summary located at the end of this guide.
To recharge your system, plug in the type-C USB connector of your recharge cable into the Type-C USB
port located in the rear of the left edge of your BrailleNote Touch. Since this is a type-C USB connector,
you don't have to worry about plugging it upside down.
If this isn't already done, plug in the USB connector of your recharge cable into the power adaptor, then
plug the power adaptor into a power outlet.
Setting Up your
System
Recharging your
system
15