Related Manuals for oviala ATHENES
Summary of Contents for oviala ATHENES
- Page 4 Step 6 Located holes in *Place centre lou size.* Place centre lou...
- Page 5 Step 6 Located holes in centre of beams(ⒶandⒷ) *Place centre louver Ⓗinto 12th slot, lining up w size.* Place centre louver Ⓗinto 16th slot, lining up wi Using M10 nut ⑤X2, secure the louver in place Place Driving louver Ⓘin line with 4th slot on the Fit all common louvers ⒼX21 for 300x300cm centre of beams(ⒶandⒷ) the remaining slots in the beams...
- Page 6 th the holes for 300x300cm h the holes for 300x400cm. beam ⒶandⒷ. and ⒼX30 for 300x400cm size into 0x300cm x400cm. One for each other of the slats is required.
- Page 8 Place Driving lou Fit all commo the remainin...
- Page 9 Using M10 nut ⑤X2, secure the louver in place ver Ⓘin line with 4th slot on the beam ⒶandⒷ. Place Driving louver Ⓘin line with 4th slot on the beam ⒶandⒷ. Fit all common louvers ⒼX21 for 300x300cm and ⒼX30 for 300x400 louvers ⒼX21 for 300x300cm and ⒼX30 for 300 the remaining slots in the beams g slots in the beams...
- Page 10 *Use bolt⑥x46, plastic spacer⑦x46 and nut⑧x46 to tighten for 300x300 cm Use bolt⑥x64, plastic spacer⑦x64 and nut⑧x64 to tighten for 300x400 cm Secure the louvers at each end. cm size into 400cm size into NOTE: Do not over tighten. Over tightening will prevent louvers from moving One for each other of the slats is required.
- Page 11 is used along...
- Page 12 Fix Ⓙx 2 (flat L-shap...