Maintenance And Cleaning; Troubleshooting - Parkside PTPU 1500 A1 Operation And Safety Notes Translation Of The Original Instructions

„
Make sure that there are no air bubbles trapped in the hose. These would have a negative effect on
the power. To do this, lay the hose so that it ascends and avoid loops.
„
Position the pump
level. Align the pump
„
Do not place the pump
raised, such as, for example, on a stone.
„
Never use the pump
would damage the pump
„
By rotating the filter grille
anti-clockwise: more flow. (see Fig. C)
„
In order to achieve the very best pumping results, the pump
„
Only allow the pump
„
If you use the pump
sand as possible.
NOTE: In order to achieve the maximum water flow, you must keep the hoses as short as possible.
Also, as far as possible there should be no kinks and/or large height differences. Ideally, you should use
hoses with the largest possible diameter, in order to achieve the greatest possible water flow rate.
z Maintenance and cleaning
„
The pump has been manufactured in a reliable, high-quality design, where the non-contact pump
1
wheel mechanism ensures a long period of operation. However the pump wheel unit
to contamination from the operating environment and must not be damaged.
CAUTION: In order to clean the pump
by unplugging the mains plug
through moving parts.
„
Always keep the mains plug
socket. In case of doubt, please contact your electrical specialist.
„
In order to clean the pump
front cover use a narrow flat-blade screwdriver to help you, if necessary. The round cover of the
4
pump wheel unit
The pump wheel unit
remove any dirt which is stuck on.
CAUTION: The pump shaft cannot be removed. Re-assemble the pump
following the instructions in reverse order.
„
Monthly maintenance will increase the service life of the pump
z Troubleshooting
If the pump does not work, check the following:
1
1. Check that there is sufficient water around the pump
2. Check the residual current protection switch of your mains socket and use another socket to make
sure that the pump
from the socket
2
3. If, when the pump is running, you can hear abnormal noises, check the pump wheel unit
To do this, unscrew the nozzle connector
fully below the surface of the water, ideally at least 10 cm under the water
1
so that it is as level and horizontal as possible.
1
directly onto slimy or sandy surfaces. The ideal position is for it to be
1
without the filter grille
1
.
1
you can regulate the flow rate. Turning clockwise: less flow; Turning
5
to operate when it is completely submersed in water.
1
in an ornamental pond, position the pump
1
from the voltage supply. There is a risk of electric shock or risk of injury
2
dry, before you connect the pump
2
, remove the front cover
1
has a bayonet connector and can be undone by turning it anti-clockwise.
8
will simply be pulled out forwards. Use a small, soft brush or a water jet to
9
is being properly supplied with power. NOTE: Always unplug the mains plug
1
before you touch the pump
. This prevents the ingress of coarse dirt which
5
must be positioned on a flat surface.
1
or carry out maintenance work, always disconnect it first
1
and the pump wheel unit
4
.
1
.
1
or from the pump in order to obtain access to the
6 7
in an area which is as free of
1
9
back to the mains power
1
. To lift off the
9
after cleaning by
1
.
1
GB/IE/NI/CY/MT
is susceptible
.
9
11