Advertisement
Read the instruction leaflet
EN
and safety instructions carefully before use.
1. GENERAL DESCRIPTION
1. Handle
2. On/O switch (0-1-2)
3. Swivel power lead
4. Styling iron
5. Eject button
Accessories:
6. Styling iron (16 mm diameter)
7. Crimper
8. Ceramic crimping plates
9. Ceramic straightening plates
10. Storage case
11. Hair dryer (depending on model)
2. SAFETY PRECAUTIONS
• For your safety, this appliance complies with the applicable standards and regulations
(Low Voltage Directive, Electromagnetic Compatibility, Environmental...).
• The appliance's accessories become very hot during use. Avoid contact with the skin.
Make sure that the supply cord never comes into contact with the hot parts of the
appliance.
• If using this appliance in the UK it should not be used in a bathroom. If using the
appliance in another country then as an additional safety measure we
recommend to check that the voltage of your electricity supply matches the
voltage of your appliance. Any error when connecting the appliance can cause
irreparable harm, not covered by the guarantee.
• As an additional safety measure, we recommend the installation of a residual current
difference device in the electrical circuit supplying the bathroom, acting at not more
than 30 mA.Ask your installer for advice.
• The installation of the appliance and its use must however comply with the standards in
force in your country.
• CAUTION: Never use your appliance with wet hands or near water contained
in bath tubs, showers, sinks or other containers...
• Do not use this appliance in a bathroom if you are in the UK. If you are outside of the
UK and you are using the appliance in a bathroom, unplug it after use as the presence of
water nearby may pose a danger even when the appliance is turned o .
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety. Children should be supervised to ensure that
they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly quali ed persons in order to avoid a hazard.
• Stop using your appliance and contact an Authorised Service Centre if:
- your appliance has fallen.
- it does not work correctly.
• The appliance is equipped with a heat-sensitive safety device. In the event of overhea-
ting (for example if the rear grill is blocked), the styler will stop
automatically. Contact a service agent for further advice (see separate service leaflet).
• The appliance must be unplugged:
- before cleaning and maintenance procedures.
- if it is not working correctly.
- as soon as you have nished using it.
- if you leave the room, even momentarily.
• Do not use if the cord is damaged.
• Do not immerse or put under running water, even for cleaning purposes.
• Do not hold with damp hands.
• Do not hold the appliance by the casing, which is hot, but by the handle.
• Do not unplug by pulling on the cord, rather pull out by the plug.
• Do not use an electrical extension lead.
• Do not clean with abrasive or corrosive products.
• Do not use at temperatures below 0°C and above 35°C.
GUARANTEE:
This product has been designed for domestic use only. Any commercial use, inappro-
priate use or failure to comply with the instructions, the manufacturer accepts no
responsibility and the guarantee will not apply.
3. GETTING STARTED
Attaching and removing accessories:
• For the hair dryer (depending on model):
Attach the hair dryer directly to the handle by locking the ring, without using the styling
iron. To remove it, follow the above procedure in reverse order.
• For other accessories:
All the accessories are attached in the same way.
Attach all the accessories when the appliance is cold to avoid the risk of burns.
1. Attach the accessory to the styling iron (Fig. 1).
2. Attach the styling iron to the handle and turn the locking ring on the handle to lock
the accessory in place (Fig. 2).
• To remove the accessories:
1. Remove the styling iron from the handle by unlocking the ring.
2. Press the eject button on the styling iron and remove the accessory.
NB: To change the straightening plates or crimping plates, pull the end of the plates and
slide the plates as shown in the diagram (Fig. 3).
The straightening plates and crimping plates form a single accessory. To change them,
just turn over the plates.
When putting the plates back in position, be sure to clip them as far into their casing as
they will go.
When removing accessories, always hold them by the plastic part - the metal parts will
be very hot.
Plugging in your appliance:
When you have attached an accessory to the handle, place the appliance on a flat
surface.
• Plug it in and set the switch to position 1 or 2.
• Wait a few minutes to allow your appliance to reach its working temperature (6 min for
the styling iron; 7 min for the straightening and crimping plates).
The ceramic coating of the plates will protect your hair from excessive temperatures, by
distributing the heat uniformly.
4. OPERATION
Use this product on clean, untangled, DRY hair (to avoid damaging your hair).
6
1 - STYLING IRONS
- Gather a small section of hair (approx. 2 to 3 cm across).
- Press the lever to open the tong, then slip the tips of the hair between the roller and the
tong.
- Release the lever to close the tong. Check that all the hair tips are correctly wound
under the tong, in the direction of the curl.
- Hold the insulated plastic end with the other hand.
- Turn the styler to wind the section of hair around the accessory. Wind the hair, working
towards the scalp. Take care not to burn yourself.
- Keep the iron in place for around 20 seconds (longer for tighter curls).
- Unwind the iron halfway, then open the tong and allow the section of hair to slide free.
- Repeat the procedure with different sections of hair to form more curls.
PROFESSIONAL TIPS
• To create extra volume: divide your curls using your fingers.
• To obtain really tight curls: wind small sections of hair at a time.
• For softer curls: wind on more hair.
• To prevent flyaway ends: check that the hair tips are trapped under the tong and lying
in the direction of the curl.
• For a more natural, wavy look: lightly brush or comb your hair once the curls have
cooled.
7
2 - CRIMPER
- Gather a section of hair approximately 5 cm across, starting at the root of the hair.
- Press the lever to open the crimper attachment, and place the hair between the
crimping plates.
- Close the crimping plates for around 10 seconds.
- Release the hair and start again just below the wave just formed.
PROFESSIONAL TIPS
• Always work from the roots towards the tips of the hair.
• To enhance the effect, you can apply styling mousse before crimping.
8
3- STRAIGHTENER
- Your hair should be dry and tangle-free.
- Gather a section of hair approximately 5 cm across, starting at the root of the hair.
- Press the lever to open the straightening attachment, and place the hair between the
straightening plates.
- Slide the appliance slowly down from the root to the tip of the hair.
PROFESSIONAL TIPS
• To avoid kinks in long sections of hair, use a smooth, continuous movement.
• To enhance the effect, you can apply styling mousse before straightening.
5. CLEANING
• Unplug the appliance and leave it to cool.
• Clean the accessories when fully cooled. For the hair dryer, you can clean it with a
slightly damp cloth to remove any hair or impurities that may be clinging to the rear grid.
• To clean the handle, wipe with a soft damp cloth. Never allow water or any other liquid
to enter the handle.
6. ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it a local civic waste collection point.
Advertisement
