Figure 6
1. Counter weight
3. On right end of cutting unit, remove the plastic plug
from the bearing housing
4. Remove the 2 bolts from the right side plate
2
Figure 7
1. Plastic plug
5. Install the counter weight to the right end of the cutting
unit with the 2 screws previously removed.
6. Loosely install the 2 reel motor mounting bolts to the
left side plate of the cutting unit
(Figure
7).
(Figure
1
G003321
2. Bolts (2)
(Figure
7).
5
Adjusting the Cutting Unit
Steering
No Parts Required
Increased Steering for the Rear Cutting
Units
Increase the steering on the rear cutting units by removing
the 2 pivot spacers, hex socket screws and flange lock nuts
(Figure
8) from the rear (#2 and #3) cutting unit carrier
frames
(Figure
9).
7).
1. Hex socket screw
2. Pivot spacer
6
1
2
3
G015978
4
Figure 8
3. Carrier frame
4. Flange lock nut
Figure 9