Samsung WA1635D0DW/XAP Service Manual page 18

4-3 AFTER SERVICING
1. Choose a place to install the washing machine.
- Decide the drain hose direction according to
the place to install.
- Leave at least 10cm space between the
washing machine and the wall.
2. Adjust the height control legs to make even.
* Adjust the level after placing the machine
on the floor properly.
a. After lifting up the machine pull out the
handle of adjustable leg at the front and
pust it aside.
b. Adjust the height lifting up and down the
machine.
c. Check the horizontal level at the right side
of the front.
d. Fix it using the handle of adjusting leg.
* If the machine may not be installed even it
may cause vibration or damage.
Be sure to install it even.
* How to adjust it even
Drop water
Cause
position
The front is
lower
The rear is
lower
The left is
lower
The right is
lower
3. When you arrange the wire harness at the bottom
part, make sure the wires are not affected by any
tension around. (If you ignore tension, it may
cause vibration or noise during spinning.)
4. After removing TOP-COVER, check if the AIR-
HOSE is inserted between the groove of OUT-
CASE and TOP-COVER. (possible cause of 'Bad
Drain'or 'No Water Supply' Error.)
CAUTION
* When replacing TOP-COVER, there may be a
danger of P/L case as the WIRE is damaged due
to POWER-CORD WIRE protruded outside
TOP-COVER when assembling COVER-TC. Be
sure to check if the WIRE is deviated out to the
TOP-COVER.
D
Solution
Use height control leg
Use height control
rubber or a support
Adjust the left side
using height control leg
(front) and height
control rubber (rear)
Adjust the right side
using height control leg
(front) and height
control rubber (rear)