Advertisement
Prior to Installation
Precautions for installation
• It is recommended that this device be installed in a 19-inch rack
case, rather than under general consumer environment conditions.
• Make sure that the ambient temperature inside the rack does not
exceed 35°C.
• If installing more than one M-Box, ensure that there is a space
of at least 1U (approximately 44.45 mm) between the M-Boxes to
HDMI IN
prevent the vent on top of each M-Box from being blocked.
• Make sure the vent faces upward. Do NOT install the device in
portrait orientation or upside down.
• Make sure the vent on top is not blocked to prevent the device
from overheating.
• Exercise caution to ensure that no foreign material enters the vent
on top of the device.
• If installing the device close to a wall, make sure that there is a
space of at least 10 mm between the wall and the four sides of the
DP IN
device to ensure good ventilation.
• Make sure that there is a space of at least 50 mm between the wall and
the rear ports of the device to gain access for connection of cables.
• Make sure at least 15.2 m (50 ft) distance is ensured between the
modem and the Bluetooth/Wi-Fi module.
Connecting and using devices
DVI/MAGICINFO IN
Connecting to a PC
DVI/HDMI AUDIO IN
HDMI IN
HDMI IN
DP IN
DVI/HDMI AUDIO IN
Connecting a Optical Cable
ONE CONNECT
DVI/MAGICINFO IN
HDMI IN
DVI/HDMI AUDIO IN
DVI/HDMI AUDIO IN
Troubleshooting Guide
HDMI IN
Issues
Solutions
The screen keeps
Check that the cable between the product
switching on and off.
and the PC is connected correctly.
DVI/HDMI AUDIO IN
Check that the product is connected
No Signal is
correctly with a cable.
displayed on the
Check that the source device connected to
screen.
the product is powered on.
This message is displayed when a
signal from the graphics card exceeds
HDMI IN
the product's maximum resolution and
frequency.
Not Optimum Mode
is displayed.
Refer to the Standard Signal Mode Table
and set the maximum resolution and
DVI/HDMI AUDIO IN
frequency according to the product
specifications.
Installing M-Box on Rack Case
Screw
(M4 x L8)
Screw
(M5 x L12)
HDMI IN
Attach the brackets to both sides of the M-Box main unit.
1
Fix the M-Box to the rack case.
2
* Use appropriate screws that are compatible with the rack case
size.
DP IN
DVI/MAGICINFO IN
Connecting to a Video Device
DVI/HDMI AUDIO IN
HDMI IN
HDMI IN
DP IN
DVI/HDMI AUDIO IN
Connecting the LAN Cable
LAN
DVI/MAGICINFO IN
HDMI IN
Use a cable of CAT 6 (*STP type) or higher.
DVI/HDMI AUDIO IN
DVI/HDMI AUDIO IN
* STP: Shielded Twisted Pair
* Connect to a HUB or router that supports the DHCP function.
HDMI IN
Issues
Solutions
There is no image
The status of product is in power-saving
on the screen and
mode.
the power indicator
DVI/HDMI AUDIO IN
Press any key on the keyboard or move the
blinks every 0.5 to 1
mouse to return to the previous screen.
second.
Make sure that the batteries are correctly in
place (+/-).
Check if the batteries are flat.
HDMI IN
The remote control
Check for power failure.
does not work.
Make sure that the power cord is connected.
Check for any special lighting or neon signs
DVI/HDMI AUDIO IN
switched on in the vicinity.
Specifications
Model Name
Horizontal Frequency
Synchronization
Vertical Frequency
Optimum Resolution
Resolution
Maximum Resolution
Power Supply
Based on the AC voltage of the adapter. For the DC voltage of the product, refer to the
Operating
Environmental
considerations
Storage
Supported models
* This device is a Class B digital apparatus.
* For detailed device specifications, visit the Samsung Electronics website.
* The PVC Free (except for accessory cables) logo is the self-declared trademark of Samsung.
- Accessory cables: signal cables and power cords
Warning! Important Safety Instructions
Please read the appropriate section that corresponds to the marking on your Samsung product before attempting to install the product.
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). THERE ARE NO USER SERVICEABLE
PARTS INSIDE. REFER ALL SERVICING TO QUALIFIED PERSONNEL.
» If your equipment uses an AC adapter:
- Only use the AC adapter with your product by
Samsung.
- Do not use the power cord with other products.
» Do not install this equipment in a confined space such as a case
or similar.
» The slots and openings in the cabinet and in the back or bottom
are provided for necessary ventilation. The slots and openings
must never be blocked or covered.
» The product should be located away from heat sources such as
radiators, heat registers, or other products that produce heat.
This product is RoHS compliant.
This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger,
headset, USB cable) should not be disposed of with other household waste at the end of their working life. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, please separate these items from
other types of waste and recycle them responsibly to promote the sustainable reuse of material resources.
For more information on safe disposal and recycling visit our website www.samsung.com/in or contact our Helpline numbers
- 1800 40 SAMSUNG (1800 40 7267864) (Toll-Free) / 1800 5 SAMSUNG (1800 5 7267864) (Toll-Free)
Contact SAMSUNG WORLD WIDE
If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care centre.
Tel. 1800 40 SAMSUNG (1800 40 7267864) (Toll-Free) / 1800 5 SAMSUNG (1800 5 7267864) (Toll-Free)
www.samsung.com/in/support
SBB-MBOX
15 – 255 kHz
24 – 120 Hz
3840 x 2160 @ 60 Hz
7680 x 4320 @ 60 Hz
AC100-240V~ 50/60Hz
product label.
Temperature: 0 °C – 40 °C (32 °F – 104 °F)
Humidity: 10% – 80%, non-condensing
Temperature: -20 °C – 45 °C (-4 °F – 113 °F)
Humidity: 5% – 95%, non-condensing
IW008R
This symbol indicates that high voltage is present
inside. It is dangerous to make any kind of contact
with any internal part of this product.
This symbol indicates that this product has
included important literature concerning
operation and maintenance.
» Do not place a vessel containing water (vases etc.) on this
apparatus, as this can result in a risk of fire or electric shock.
(Apparatus shall not be exposed to dripping or splashing)
» The apparatus must be connected to an earthed MAINS socket-
outlet (Class l Equipment only). Or Use only a properly grounded
plug and receptacle (Class l Equipment only).
» To disconnect the apparatus from the mains, the plug must be
pulled out from the mains socket, therefore the mains plug shall
be readily operable.
» As long as this unit is connected to the AC wall outlet, it is not
disconnected from the AC power source even if you turn off this
unit by POWER.
Advertisement
