Table of Contents
Advertisement
1.1 Standard use of power supply
Use the power adapter that comes with the machine;
Do not use the plug with wet hands and do not touch the parts with safety tips;
Make sure the plug is plugged into the power socket;
Do not modify the equipment to prevent printer damage ;
If you do not use printer for a long time, unplug the power cord from the power socket.
1.2 Printing attention
Do not touch the heating structure inside the printer while the printer is printing ;
Do not touch the running parts when the printer is working to avoid accidental damage ;
Do not use the product on an inclined or unstable platform ;
Please use the printer on a well-ventilated and flat platform ;
In case of emergency, please turn off the printer directly;
When printing a model whose length exceeds the length of the body, it is recommended to
use a tray to accept the model;
When there is an error between the length in the Z-axis direction and the actual model, you
can try to adjust the Z step;
The deviation of the rack angle may affect the accuracy of the model;
If it's not used for long time after printing, it is recommended to remove filament from printer.
1.3 Printer maintenance
Do not attempt to disassemble the machine in a way not described in this manual to avoid
printer damage or other serious safety accidents ;
Periodically clean the printer with a dry cloth when the power is off ;
Properly lubricate the linear guide rail as required;
Carefully check whether the nozzle is flowing smoothly before printing and clean the nozzle
and the hot bed before printing;
If screws and nuts are found to be loose during use, please stop printing and tighten them with
wrenches or other tools;
The size of the printed model should not exceed the allowable printing range of the printer,
otherwise the success rate of model printing will be affected;
The printer cannot work under the condition of too high temperature and too heavy load, so
avoid the equipment damage caused by the overload;
After printing,it is necessary to clean the nozzle, hot bed and other parts to extend service life;
When heating the print head for cleaning, do not directly touch the print head with your hands
to avoid scalding.
Ⅰ.Attentions
2
珠 海 贝 尔 科 技 有 限 公 司
Zhuhai Bell Technology Co., Ltd
Advertisement
Table of Contents
