Environment Concerns - Dometic WMD 1050 User Manual

650-800 mm
The drain hose can be connected directly
into the pipe (e.g. beneath a washtub or
sink), above the water trap. The drain hose
must be arranged so that some part of it's
length is routed up to a level corresponding
to the top edge of the tub and fixed in place
there.
Directly into a drain pipe at a height of
not less than 65 cm and not more than 80
cm.
Their must be an air gap around and below
the end of drain hose. This means that the
Information on the electrical connection is
given on the rating plate on the inner edge
of the appliance door.
Check that your domestic electrical installa-
tion can take the maximum load required,
also taking into account any other applian-
ces in use.
Connect the machine to an earthed
socket.
The manufacturer does not accept
any responsibility for damage or

Environment concerns

The symbol on the product or on its
packaging indicates that this product may
internal diameter of the standpipe must be
larger than the outer diameter of the hose.
The hose must not be sticked into the
standpipe more than 50 mm and it has to
be fixed in this position. The drain hose
must not be kinked.
The drain hose can be extended up to total
3,5 m. For the extension piece use a hose
with an internal diameter at least as large as
that of the machine's own hose. Use a suit-
able hose connector.
injury through failure to comply
with the above safety precaution.
The power supply cable must be
easily accessible after installing the
machine.
Should the appliance power supply
cable need to be replaced, this
must be carried out by a Service
Centre.
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
19
40 mm
650-800 mm