Dometic WMD 1050 User Manual page 17

2. Return machine to it's upright position
and remove the power supply cable
and the draining and inlet hose from the
hose holders on the rear of the appli-
ance.
3. With a suitable spanner unscrew and
remove the three screws and their
spacers on machine's rear.
4. The three holes must then be plugged
with the plastic plug caps supplied in
the bag containing the instruction
booklet, which can be found inside the
drum.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or furniture. Level the wash-
ing machine by raising or lowering the two
front feet. If necessary, check the setting
with a spirit level. Any necessary adjustment
can be made with a spanner. Accurate lev-
elling prevents vibration, noise and dis-
placement of the machine during operation.
17