Subscribe to Our Youtube Channel
Related Manuals for Metaform PICO HYBRID
Summary of Contents for Metaform PICO HYBRID
- Page 1 USER MANUAL Part List and Assembly Instructions Including: 3.00mm Bowden Setup Direct Drive Setup Additional Part Fan Nozzle Changing...
- Page 2 Small Phillips Screwdriver 0.9mm and 2mm 7mm and 11mm Small Parts Bowden Coupler Bowden Clip Direct Drive Plug PTFE Tubing Pico Hybrid Assembly 1.75mm and 3.00mm 2x4mm and 3x4mm Fan Voltage Regulator Voltage Regulator Wiring Harnesses Heat Break Cooling Fan Thermistor...
- Page 3 IMPORTANT NOTES Wire Length Shortened Wire Length Cutoff Connected Terminals - Sizing of parts may vary across illustrations to enhance relevant details. - Wiring length is not reflective of the actual wire length and is shortened for simplicity. - Previous assembly steps may not be visible for each stage of setup. Step 1 Using the 1.2mm set screw Allen wrench, loosen the set screw locking the groove mount to the heatsink and unthread the groove mount so that the top of the heatsink is accessible.
- Page 4 Step 4 Step 5 Push the heat break cooling fan into the heatsink, Thread the thermistor into either the left or right side of with the nubs between the 2nd and 3rd fin from the the heater block top. Users with the part cooling fan should refer to that manual during this step. Step 6 Step 7 Push the 3.00mm Bowden coupler...
- Page 5 The tube should extend all the way down to the top edge of the heatsink as shown. Please refer to the wiring diagrams on the User Guides page of the Metaform website for wiring the hotend to the printer.
Need help?
Do you have a question about the PICO HYBRID and is the answer not in the manual?
Questions and answers