Initial Alternative Configuration Through Web Client - golmar iPG+ CE-ART 7/G+ Installer Manual

IP G+

5. INITIAL ALTERNATIVE CONFIGURATION THROUGH WEB CLIENT

The guard unit also allows to do its initial configuration through the Web Client. For this, we need a computer and be able to connect to
the network where is connected the guard unit.
The steps to follow are described below:
First, make sure your computer is in the same IP range as the server. For this, follow the next steps:
1
Go to network settings in control panel.
3
Enter into "properties".
In this moment the computer is configurated to work in the same IP range as the guard unit.
Only will left::
Type the IP in the web browser:
10.0.14.9
Search
To do the initial configuration in this way, it should do one by one as devices are connected to the network. Since all devices in the G+
range have the same factory IP address..
www.golmar.es
4
Select Internet
protocol IPv4.
factory IP 10.0.0.254
GO
2
Change the active Ethernet network.
5
Set the IP range.
Do not assign DNS
Access the Web Client:
10.0.14.9
Search
The password to access is 888999.
CE-ART 7/G+
IP address should start
Next three numbers should
have a value lower than
Assign 10.0.0.1 as Gateway.
Confirm settings.
GO
6