Installation - Valex MIX1200 Operating Instructions Manual

g
WARNING! The mixer is suitable for mixing
! !
fluid substances such as paint, varnish,
mortar, plaster, glue. It is forbidden the use
of hazardous materials and the use in areas
with a risk of fire/explosion.
This instruction guide contains information and
as deemed necessary for the proper use, the
knowledge and the normal maintenance of the
tool. They do not report information on mixing
techniques , the user will find more news about
books and publications or by attending courses.
SYMBOLS
Carefully observe the symbols in fig.B and
memorise their respective meanings. Correct
interpretation of the symbols allows a safer use
of the machine.
1 Technical data
2 Double electric insulation
3 Electric and electronic waste may contain
potentially hazardous substances for the
environment and human health. It should
therefore not be disposed of with dome-
stic waste, but by means of differentiated
collection at specific centres or returned to
the vendor in the event of purchasing a new
identical power tool. The illegal disposal of
waste will result in administrative sanctions
4 Certifications
5 Lot number
V Volt
Hz Hertz
~ alternating current
W Watt
kg kilograms
mm millimetres
s seconds
n no-load speed
0
min round per minute
-1
dB decibel
COMPONENTS
Refer to fig.A and the following, attached to
these instructions.
1 Power On / Off
2 Handle
3 Speed control
4 Safety button
5 Threaded connection (M14)
6 Whip
7 Louvers
8 Plug and power cord
9 Support rod
10 Key/s for mounting accessories (if present)

INSTALLATION

WARNING! The manufacturer disclaims
! !
any liability for any direct and/or indirect
damages caused by improper connection.
! ! WARNING! Before you perform the fol-
lowing steps, make sure that the plug is
disconnected from the mains.
TRANSPORT
To carry the tool always use his or her packa-
ging, this will preserve it from bumps, dust and
moisture that may affect proper operation.
HANDLING
Unplug the power plug, securely hold the tool
with both hands, gripping it on the handle, wi-
thout pressing the switch.
COMMISSIONING
In the place that you will use the power tool you
should consider :
- That the area is not damp and is sheltered from
the elements.
- Which is provided around a large working area
free from obstructions.
- That there is good lighting.
- Which is used in the vicinity of the main switch
with differential.
- That the fuel system is equipped with a groun-
ding in accordance with the rules (only if the
tool is in class I, equipped with a plug with
ground wire) .
- That the ambient temperature is between 10
° and 35 °C.
- That the environment is not in the atmosphere
of flammable/explosive.
- 9 -