Download Print this page

Digilin Spike Installation Manual

Pool, pond & garden fixture

Advertisement

Quick Links

Spike – Pool, Pond & Garden Fixture
Installation Guide
Notes
Installation should only be performed by a qualified professional
Install in accordance with all appropriate wiring standards
Never connect a LED fitting to a driver that is powered. Doing so may result in damage to the LED.
Always make sure the output voltage range and output current of the LED driver match the
requirements of the LED fitting. Failure to do so may result in damage both the driver and fitting.
Warranty void if damage is caused by water ingress through cables. Cable join must be sealed or in a
dry location. Water entering the cable may damage this fitting.
The light source of this luminaire is not replaceable; when the light sources reaches its end of life the
whole luminaire shall be replaced.
Do not install under mechanical stress.
Allow for expansion due to changes in temperature.
Please be aware that while the system has a very long operational life, faults may still occur, and
provision needs to be made for maintenance.
Always turn off power before working on fitting.
Warranty void if damage is caused by water ingress through cables. Cable join must be sealed or in a dry location.
This is an extra low voltage product
Avoid excessive strain on the fitting cable fixing during installation. Take care not the nick or damage the cable. Always terminate in a dry location or
use a suitable sealed connection.
We recommend either that full unjoined cables be used (back to a dry location) or a suitable weatherproof joining method be used.
There are many standard ways that fully waterproof reliable connections can easily be made if a loop wiring system is required. These include electric
junction boxes that are filled with one of the readily available potting encapsulates specifically made for this type of application.
Specifications
Dimensions – Standard
Weight
digilin.com.au
+617 3899 1267
U n i t s
45.2 x 79
mm
640
g
Document Rev: 1.0 - 3 February 2022
Product specifications are subject to change without notice
©2022 Digilin Technologies
Page 1 of 3

Advertisement

loading

Summary of Contents for Digilin Spike

  • Page 1 Spike – Pool, Pond & Garden Fixture Installation Guide Notes Installation should only be performed by a qualified professional • Install in accordance with all appropriate wiring standards • Never connect a LED fitting to a driver that is powered. Doing so may result in damage to the LED.
  • Page 2 Spike - Pool, Pond & Garden Fixture Installation Guide Installation Press stake into ground with Run continuous cable from luminaire back to dry Turn on power. light roughly aligned in desired location to make any joins and connect to power direction.
  • Page 3 Spike - Pool, Pond & Garden Fixture Installation Guide Wiring Diagram Standard Fittings Dimmable Fittings RBG Fittings L E D W i r e C o l o u r Black Green Green Yellow Blue Blue White digilin.com.au +617 3899 1267...

This manual is also suitable for:

Spk