Advertisement
Spike - Pool, Pond & Garden Fixture
Installation Guide
Installation
1.
Press stake into ground with
light roughly aligned in desired
direction.
4.
Adjust fitting tilt to desired
angle.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
Run continuous cable from luminaire back to dry
location to make any joins and connect to power
supply/further fittings.
If insufficient cable has been ordered with the
luminaire, a waterproof cable join, using an
approved waterproof cable joining kit in
accordance with Wiring Regulations must be
undertaken.
3.
Turn on power.
www.digilin.com.au
Page 2 of 3
Advertisement
