Setting For Operation; Electrical Connections - Abexo RM620 Manual

RM620

SETTING FOR OPERATION

The RM620 movement detector can be configured in mono direction mode (one direction
only) or in bi directional mode (in both directions).
Remove the rubber plug from the lower section of the detector (Fig. 1-A) and set the
required function through the dip-switch (Fig. 1-B), choosing from the possibilities
indicated in the table:
DSW1 DSW2 DSW4
OFF - ON
OFF - OFF
ON OFF ON
ON OFF OFF
ON ON ON
ON ON OFF
ASSEMBLY AND ORIENTATION
RM620 can be installed at the centre of the door to be controlled or on the side, on non-
vibrating structures (walls or ceiling) and at a maximum height of 6 m. Use the template
supplied to prepare the holes.
Fasten the device using the prepared holes, remove the lower cover (Fig. 2-A) and
loosen the screw that blocks the detector orientation. Direct the detector toward the area
to be controlled and lock in that position.
For correct operation, do not install RM620 :
- facing the moving parts of the door
- facing fluorescent lights (minimum distance 2m)
- facing areas where rain could provoke water fluxes
These conditions could activate the device and cause the unwanted opening of the door.

ELECTRICAL CONNECTIONS

Connect the pre-wired cable as indicated in table 1 then power the detector.
6
6
SENSITIVITY CONDITION
Low Movement is detected in both directions
High Movement is detected in both directions
Low Approach to the sensor is detected
High Approach to the sensor is detected
Low Movement away from the sensor is detected
High Movement away from the sensor is detected
www.abtecno.com
ENGLISH
www.aperioaccess.it