Black & Decker BXVMB700E Original Instructions Manual page 7

♦ Retract the cable by pressing the roller cable button and
guide the cable into the appliance.
♦ Clean the appliance.
Carry handle/s:
♦ This appliance has a handle on the front part of the body,
which facilitates comfortable transportation (Fig.2).
Parking position:
♦ This appliance has two parking positions for comfortable
and straightforward storage.
♦ To make use of the vertical parking put the appliance in
a vertical position (so that the back part of the appliance
is now leaning against the floor) secure the hook of the
floor brush to the hook which can be found on the lower
part of the appliance (Fig.3).
♦ To make use of the horizontal parking hook the floor
brush's hook onto the hook that is to be found on the
lower part of the appliance (Fig.4).
CLEANING
♦ Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
♦ Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
♦ Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
♦ Never submerge the appliance in water or any other
liquid or place it under running water.
Changing the dust bag:
♦ Change the dust bag when there is a noticeable reduc-
tion in the suction power of the appliance. (The dust bag
does not necessarily have to be full to need changing;
for example, if very fine dust has been vacuumed this
can cover the pores in the bag and make it necessary to
replace it).
♦ Disconnect the hose from the vacuum cleaners air
intake. (Fig.1).
♦ Open the bag compartment cover (Fig.5).
♦ Remove the bag from the bag support (Fig.6).
♦ Check the condition of the motor filter.
♦ Replace the bag with another one, fitting it to the bag
support.
♦ Close the bag compartment cover, making sure it is shut
properly.
♦ Connect the hose to the vacuum cleaners air intake.
(Original instructions)
Changing the filters:
♦ Motor filter, it is advisable to be changed at least once a
year or every 100 hours of the appliance's use.
♦ Air outlet HEPA filter (high efficiency air filter that
efficiently retains spores, ash, sawdust, pollen...), it is
advisable to change it a least once a year or after every
100 hours of use.
To remove the filters:
♦ Open the bag compartment cover (Fig.5).
♦ Motor Filter:
♦ The filter motor can be found in the motor's turbine air
entrance, back the dust bag.
♦ Remove the piece that holds the filter (Fig.7).
♦ To reassemble the filter, proceed with the above instruc-
tions, in reverse order.
♦ HEPA Filter:
♦ The HEPA filter can be found in the bag compartment
dust bag.
♦ Remove the piece that holds the filter (Fig.8).
♦ To reassemble the filter, proceed with the above instruc-
tions, in reverse order.
Supplies
♦ Supplies can be acquired from distributors and au-
thorised establishments (such as filters, etc...) for your
appliance model.
♦ Always use original supplies, designed specifically for
your appliance model.
♦ These supplies are available in specialist shops.
ANOMALIES AND REPAIR
♦ Take the appliance to an authorised technical support
service if product is damaged or other problems arise.
Do not attempt to disassemble or repair the appliance
yourself as this may be dangerous.
For EU product versions and/or in case that
it is requested in your country:
Ecology and recyclability of the product
♦ The materials of which the packaging of this appliance
consists are included in a collection, classification and
recycling system. Should you wish to dispose of them,
use the appropriate public recycling bins for each type
of material.
ENGLISH
7