Projection Relationships - Panasonic ET-EMW200 Operating Instructions Manual

Projection relationships

The dimensional relationship between the screen and the projector is shown below.
■ Dimensional relationship diagram
Projected image
Note
z This diagram assumes that the size and position of the projected image will be adjusted so
that the image fills the entire screen.
z This illustration is not drawn to scale.
L Projection distance
LW Minimum distance
LT Maximum distance
L1 Lens protrusion dimension
SH Projected image height
H Distance from the lens center to the lower edge of the projected image
SW Projected image width
SD Projected image size
z Dimension for L1 (approximate values)
Projector
ET-EMW200 ET-EMW300 ET-EMW400 ET-EMW500 ET-EMS600 ET-EMT700 ET-EMT800 ET-EMU100
model
PT-MZ16K /
PT-MZ13K / 0.152
PT-MZ10K
Note
z The illustrations of projectors in this manual are for informational purposes only and do not
represent a specific projector model. Configurations may vary with the model.
Attention
z To prevent blocking of the intake and exhaust vents, maintain clearances from walls and objects
of at least 1 000 mm (3'3") for the exhaust vent and at least 500 mm (1'8") for the intake vent.
z Avoid setting up in places which are subject to sudden temperature changes, such as near
an air conditioner or lighting equipment (studio lamps, etc.).
SW
0.121 0.121
L (LW/LT)
Screen
L (LW/LT)
0.122 0.117 0.167
L1
L1
(Unit: m)
0.172 0.346
ENGLISH-7