1 - INSTALLING THE CAMERA
The camera is designed to be mounted on the wall
at a minimum height of 1.6 m.
The camera can be installed in the place of an
existing light fixture. It requires connection to phase
(L) and neutral (N) conductors and earth (yellow/
green safety conductor)
Loosen the screw under the camera, using the key
provided, to remove the camera from its wall base.
The connection terminal block is unscrewed to
release the camera. To make installation easier,
unscrew the 2 screws so that only the base remains.
Mount the camera' s base using screws and wall
MOTORISED OUTDOOR IP CAMERA WITH LIGHTING
160cm
plugs suitable for the type of supporting surface
(the screws and plugs included are suitable for solid
walls).
A drilling template is provided to facilitate
installation. If the surface of the wall is uneven,
insert the provided sealing foam between the wall
and wall base.
2 - ELECTRICAL CONNECTIONS
WARNING: for obvious safety reasons, the power
supply must be switched off during installation
(circuit breaker in OFF position).
Thread the power cable through the base of the
camera, then connect as follows:
L
N
C - INSTALLATION
7
EN