Setting Up Your Camera - GoPro HERO10 Black Bones User Manual

setting Up Your Camera

INTRO TO HERO10 BlaCk BONEs
HERO10 Black Bones takes the core HERO10 Black imaging elements—
the lens, image sensor, and GP2 processor—and puts them into a design
that's made specifically for FPV. This gives you the same image quality of
HERO10 Black, plus most of its features.
Heads Up: Some of these features may not be well suited for drone
capture, but are outlined in this manual so that you can see the full
capabilities of your new camera.
sD CaRDs
You'll need a microSD card (sold separately) to save your videos
and photos. Use a brand-name card that fits these requirements:
• microSD, microSDHC™, or microSDXC™
• Rated Class V30, UHS-3, or higher
• Capacity up to 512GB
For a list of recommended microSD cards,
visit gopro.com/microsdcards.
Be sure your hands are clean and dry before handling your SD card.
Check the manufacturer's guidelines to see your card's acceptable
temperature range and other important information.
Heads Up: SD cards can degrade over time and affect your camera's
ability to save your media. Try swapping out an older card for a new
one if you're having any problems.
8
setting Up Your Camera
sD CaRD + WIRING sETUP
1. With your camera off, insert the SD card into the card slot with the
label facing the back of your camera.
You can eject the card by pressing it into the slot with your fingernail.
2. Connect your camera's wire harness to a power source on your flight
controller that is fed by a 2S-6S (5-27V) battery. Before connecting, be
sure to follow your drone manufacturer's wiring recommendations.
• Connect the red wire to your drone's flight controller battery
power pad.
• Connect the black wire to your drone's flight controller battery
ground pad.
• The yellow wire can be connected to your drone's flight
controller for trigger commands using BetaFlight.
3. Plug the male wire connector into the port on your camera.
Connect to
flight controller,
Max 5V
5-27v
2S-6S
9