Disassembly Procedure For The Unit - Panasonic TH-P50UT50A Service Manual

9.2.

Disassembly Procedure for the Unit

9.2.1. Remove the Pedestal stand
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the screws (×4
3. Slide the Pedestal stand to the downside and remove the
Pedestal stand.
9.2.2. Remove the Stand bracket cover
1. Remove the screws (×4
bracket cover.
9.2.3. Remove the AC cord clamper B
1. Remove the screws (×2
clamper B.
).
) and remove the Stand
) and remove the AC cord
9.2.4. Remove the Bluetooth module
1. Remove the screw (×1
module.
9.2.5. Remove the Rear cover
1. Remove the screws (×12
2. Remove the M8 caps (×4
3. Remove the Rear cover.
9.2.6. Remove the AC inlet
Caution:
To remove AC inlet wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Disconnect the connector (P9).
2. Remove the screws (×1
inlet.
25
) and remove the Bluetooth
, ×10 , ×2
).
).
, ×1
) and remove the AC