Samsung MWR-WG00JN Service Manual page 25

Features and Specifications
Wired remote controller installation
3) Using two or more screws, firmly affix the rear cover of the remote controller to the wall, and then cut off the
grooves of the front covers for communication and power cables, making sure these cables have reasonable length.
inch) or more
.4
inch) or more
(2
or more
secure at least 10 mm (0.4 inch)
space of upper side, left side,
right side, and 50 mm (2 inch)
space of bottom side.
4) Connect the communication cables (F3, F4) to the terminals of the back of the front cover, and then fix the wires so
that they do not get stuck during connection.
F1 F2 V1
terminal with excessive force.
• When using an electric screwdriver, tighten the screws to the standard torque because the top of screws may be worn
out if you use a strong torque.
CAUTION
.4
.4 inch) or more
Screw hole
Rear cover
Indoor
V2 F3 F4
Wire (not supplied)
Wired
Remote
Controller
Front cover
F3 F4
PCB terminal
the screw holes.
2-22