ION Total PA Spartan User Manual page 10

Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical instrument,
or microphone. Also, try to reduce the overall volume of Total PA
knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the
bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using a microphone: This is probably feedback.
Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume from your
source.
When I press Previous [<] or Next [>], it doesn't increment to the next FM station: Short presses
of the button will jump to presets. Hold the button down to seek to the next station.
If the radio station channel is flashing: The unit is currently muted. Unmute to stop the flashing and
resume playback.
If the Bluetooth logo is flashing rapidly: The unit is currently in pairing mode.
If the Bluetooth logo is flashing slowly: A device is paired, but the music is muted. Unmute to stop
the flashing and resume playback.
The USB track number (Example: 001) is flashing slowly: The USB drive music playback is muted.
Unmute to stop the flashing and resume playback.
The LCD shows "NONE": If a USB drive or SD card is already properly inserted, make sure it
contains playable files.
If you cannot connect your audio device to Total PA
•
Have your audio device (e.g., smartphone or tablet) and Total PA
possible while trying to connect. Make sure both the audio device and Total PA
unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Total PA
any other audio device and restart the search process. If this does not work right away, power
TM
off Total PA Spartan and then power it back on. See
for more information.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back on. You
can find this under the Bluetooth menu in the Settings for your phone or other audio device.
If this does not work, and you have connected to Total PA
in the list of available or previously connected devices in your audio device's Bluetooth menu, tap the
"gear" or "i" icon located next to it and then select Unpair or Forget. Turn Total PA
back on and try pairing again once it reappears in your available devices list.
TM
Note: If Total PA Spartan has been paired to another audio device recently that is still within range,
you may need to repeat this process with that audio device to fully disconnect.
10
TM
Spartan using the Master Volume
TM
Spartan via Bluetooth:
TM
Spartan to disconnect Total PA
Operation > Pairing a Bluetooth Device
TM
Spartan before, find Total PA
TM
Spartan as close together as
TM
Spartan are
TM
Spartan from
TM
Spartan off and
TM
Spartan