Advertisement
DTV Software - from Boot Up
1. Extract the upgraded file onto a USB device.
2. Unplug the TV from the AC outlet.
3. Connect the USB device to the USB slot on the side panel.
4. Press and hold the INPUT button on the TV.
5. While holding the INPUT button, plug the TV in the AC outlet and watch the LEDs on
the front of the TV.
a. After several seconds, the orange PowerOn/Standby LED and the green OnTimer
LED light is on, indicating that the TV is being upgraded.
b. Once the upgrade started, release the menu button.
6. When only the PowerOn/Standby LED is turned to green, the upgrade is completed
successfully.
If the upgrade is unsuccessful, the PowerOn/Standby LED is red.
7. Unplug the TV from the AC outlet.
8. Disconnect the USB device.
9. Plug the TV in the AC outlet.
10. After the TV is turned on, perform Factory Reset (select "Reset TV" in the Setup
Menu). Then select "Yes" to confirm reset.
Advertisement
