Indes Esense Rise Series Product Leaflet

Product leaflet esense Rise patient lift series
Always read the full user guide before use.
The user guide is available on
Product description
active
The Rise is an patient lift. With this type of lift the patient has an active role in the transfer. Rise patient lifts are
standard equipped with esense power assist drive system but are also available as manual version.
Use instructions
• Always check the patients' medical file to learn if the patient has any limitations regarding patient lift transfers.
•
Esense lifts are guaranteed to be safe to use in combination with 'esense' slings, identified by the label. When using slings
of other brands, make sure the clips are compatible with the geometry of the lugs on the lifting frame; if in doubt about
compatibility, check with the sling manufacturer. Specifications of the lugs can be found in the full user guide.
• Use the hand control to control the electrical adjustments: the leg adjustment and height adjustment of the lifting
frame. When the button is released the corresponding movement stops immediately.
• Pressing the red emergency switch immediately switches off
• In case a system fault occurs during a transfer, the patient can manually be lowered using the emergency lowering
function (pull the red/grey knob at the bottom of the actuator upwards).
• For patient lifts equipped with esense drive system – The power assist functionality is activated by sensitive
sensors in the pushbar. Ensure at all times that the pushbar can move freely and that no external forces are
exerted on the pushbar, other than the push and pull forces required for manoeuvring the lift.
Important safety instructions
• Ensure that you never lift patients weighing over the maximum weight capacity. Never lift more than one patient at
a time and never leave a patient in the lift unsupervised.
• When using the patient lift ensure that no lateral forces are being exerted on the patient, the lifting frame or the
mast: this may lead to decreased stability of the lift.
• The patient lift is not suited to be exposed to large quantities of water; e.g. it is not suited for use under a shower.
• Do not expose the lift to temperatures below -5°C or over 50°C.
• Before every use always check the slings – in particular the straps and clips – for any signs of wear or damage.
• Regularly check the lift for loosened parts (bolts, axles) and wear of e.g. rubbers, wiring, straps or plastic covers. In
case of any irregularities please stop using the lift and contact your supplier/service department immediately.
• For patient lifts equipped with esense drive system – The power assist functionality contains moving parts required
for driving and steering of the drive wheel. These components are protected by the blue cover at the back of the lift:
prevent hands or fingers from getting stuck underneath the cover and always make sure to switch off the system
before carrying out any maintenance.
Certification
All esense products are marked with a CE certification. The products are classified as class I of the Medical Devices
directive MDD 93/43/EEC. All esense products are tested and meet the requirements of NEN EN ISO 10535 'Hoist for the
transfer of disabled persons – Requirements and test methods' and NEN EN ISO 60601-1 'Medical electrical equipment'.
Product lifespan
If used and maintained correctly the average lifespan of the patient lift shall be 8 years minimum.
Cleaning
For cleaning it is best to use regular, non-aggressive and non-abrasive cleaning products (PH 5,5-8). Wipe the lift with a
well-wrung damp cloth using clean water to remove all disinfectant residue.
www.esense-moves.com on the product page of the esense Rise ("downloads" tab.
Leaflet esense Rise series EN I R 2.00 | 28-01-2021
all motors.