Refrigerant Type; Transportation, Handling, And Storage - Trane Start to Finish R-410A Installation Manual

General Information
Figure 11. Operating envelope
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
-30 -20

Refrigerant Type

Start to Finish™ compressors are approved for use with
R-410A refrigerant only. Any use of hydrocarbon
refrigerants or air is strictly prohibited!
Transportation, Handling, and
Storage
The compressor must be handled in the vertical position
(maximum 15-degree offset from vertical). Should the
compressor be handled in an upside down position, its
suitability for its use can not be guaranteed.
NOTICE
Improper Handling!
Improper handling of the compressor resulting from
being handled or transported in the upside position,
dropped or tipped over could result in internal damage
to the compressor and it is recommended that the
compressor not be put into service.
Damage to compressor or packaging should be reported
to the shipper immediately.
Use a proper method of lifting the compressor, both lifting
ears must be used with a spreader bar.
18
R410A Operating Map - Superheat 20F
-10 0 10
R410A Operating Map - Superheat 20F
20 30
Evaporating temperature (°F)
Heavy Objects!
Failure to follow instructions below or properly lift unit
could result in unit dropping and possibly crushing
operator/technician which could result in death or
serious injury, and equipment or property-only damage.
Ensure that all the lifting equipment used is properly
rated for the weight of the unit being lifted. Each of the
cables (chains or slings), hooks, and shackles used to
lift the unit must be capable of supporting the entire
weight of the unit. Lifting cables (chains or slings) may
not be of the same length. Adjust as necessary for even
unit lift.
For approximate compressor weight, see
40 50 60
WARNING
Table 4, p.
PART-SVN234B-EN
70
19.