Page 2
Go into your phone/tablet’s Bluetooth settings the power button until it powers off. and enable Bluetooth. Next, enter the Bluetooth device list and select BH70TWS. After selected, wait a few seconds for the pairing to complete. Once the pairing is successful, you will hear and audible tone from the speaker and a blue LED will flash every 3 seconds.
Page 3
Wireless Sound successfully linked together and the LED will The BH70TWS includes True Wireless Stereo slowly flash blue every 3 seconds. (TWS) technology. This enables you to link two speakers to emit a true left / right stereo sound.
BH70TWS. Tap the button to cycle between Bluetooth and Aux-In modes. While in Aux NOTE: If linked to a second BH70TWS mode, the LED will remain green. speaker, all of the controls on one BH70TWS speaker will apply to both speakers.
Page 5
To end a call, simply press the button of the speaker. Press and hold the same button to decline an incoming call NOTE: For best performance and clarity, operate the BH70TWS within an arm’s length.
Page 6
Simply insert one end of a 3.5mm audio feature, for a total output of up to 4 speakers in cable into the headphone port of a BH70TWS, sync. See illustration below for extended and insert the other end into the Aux port of any possible configurations.
Page 7
Factory Reset Specifications If you are experiencing connectivity issues, you Bluetooth Version: 4.2 may need to reset the TWS pairing. To do so, Lithium-Ion Battery: 4400mAh (2x2200mAh 3.7v) press the V+ and V- buttons simultaneously Charging Voltage: 5V Speaker: 52mm 4Ω 8W x2 for 3 seconds.