Table of Contents
Advertisement
4
Press V/v to select the setup item from the displayed list:
"Dolby Digital," "DTS," "Audio DRC," or "MPEG."
ENTER
5
Press B/b to select an item, then press O RETURN to confirm the setting.
ENTER
RETURN
6
Press O RETURN repeatedly to exit the menu.
RETURN
Menu choices
• Dolby Digital
Selects the type of Dolby Digital signal.
The default setting is indicated in bold print.
D-PCM
Dolby Digital
• DTS
Selects whether or not to output DTS signals.
The default setting is indicated in bold print.
Off
On
• Audio DRC (Dynamic Range Control)
Makes the sound clear when the volume is turned down when playing a DVD that
conforms to "Audio DRC." This affects the output from the following jacks:
– LINE OUT AUDIO L/R jacks
– DIGITAL AUDIO OUT (OPTICAL or COAXIAL) jack only when "Dolby
Digital" is set to "D-PCM."
The default setting is indicated in bold print.
Standard
TV Mode
Select this when the player is connected to an audio component
lacking a built-in Dolby Digital decoder.
Select this when the player is connected to an audio component
with a built-in Dolby Digital decoder.
Select this when the player is connected to an audio component
lacking a built-in DTS decoder.
Select this when the player is connected to an audio component
with a built-in DTS decoder.
Normally select this position.
Makes the low sounds clear even if you turn the volume down.
continued
57
Audio Setup
Advertisement
Table of Contents
