. • ORAVA electrical appliances are manufactured according to the state of the art and recognized safety rules. Nevertheless, improper and unprofessional use or use contrary to the intended use may result in injury or danger to the life of the user or third party.
Page 3
Safety of the operating environment • Do not use the device in an industrial environment or outdoors! • Do not expose the device to: - sources of excessive heat or open fl ame, - dripping or splashing water - vibration, shock and excessive mechanical stress - insects, animals and plants, - aggressive and chemical substances.
2. Special safety precautions • The electrical/electronic equipment is designed and manufactured in such a way as to allow safe operation and use by persons without professional qualifi cations. Despite all the precautions that have been taken by the manufacturer for safe use, operation and use carry some residual risks and associated hazards.
Page 5
Location/Installation • Only place the device on: - fl at, strong and stable mats - for fl oors and stable mats with a solid surface fi nish and with suffi cient load-bearing capacity. • Always make sure that the space you want to place the equipment has suffi...
Page 6
• Do not use the device near strong electromagnetic fi elds. Electromagnetic fi eld effects can affect the correctness of electronic device functions. • Store the equipment in a clean and dry place. Do not load the device when storing. •...
Page 7
Warning! • Always store batteries out of the reach of children, disabled people and pets. • Keep the used batteries in a safe place so that they cannot be swallowed by children and dispose of as soon as possible. Seek medical advice immediately if swallowed.
Page 8
Preparation Power supply The device works on three 1.5 V AAA batteries. Before using the device, you must insert the batteries into the device. Open the battery cover and insert three 1.5 V batteries. Observe the correct polarity + and -. Close the battery cover.
Switching units of measure If you need to change the weight units, you can do so by pressing the „kg/lb“ switch. The scale will then weigh in metric or English units of weight. Switch location A The switch is located on the bottom of the scale next to the batteries.
Battery replacement If „Lo“ appears on the display, the batteries must be replaced. A Open the battery compartment cover on the underside of the scale. B Remove the batteries C Insert new batteries (use only the same type). Observe the correct polarity + and -! D Close the battery cover.
Need help?
Do you have a question about the EV-520 and is the answer not in the manual?
Questions and answers