Setting up and connecting
Setting up and connecting
5
ATTENTION
Beware of the safety/warning instructions (see chapter 2 Safety).
Check the device for electrical safety to exclude any possible damage during
transport.
5.1 Unpack
Carefully unpack the device and check for:
damage during transport,
conformity with the specifications of the supply contract (type, connected loads),
completeness of the delivery!
Inform us immediately if there are differences to the contractually agreed scope of delivery or if
damage is apparent.
Remove all transport locks and adhesives from the device and remove the operating
instructions and enclosed material from the packaging.
If a warranty claim is made, the device must be returned in suitable packaging that is safe for
transport.
INFORMATION
The General Terms and Conditions of the manufacturing company apply.
The scope of delivery is determined by the delivery contract.
Keep the packaging if the device is to be returned to the manufacturer's site or
authorised workshops for repair.
5.2 Setting up
ATTENTION
Ensure sufficient ventilation or cooling.
The distance between adjacent parts and surfaces must be sufficient to prevent
the device from overheating.
Place the device on a flat horizontal surface.
5.3 Assembly
There is no need to assemble the device, as it is already fully assembled. The device only
needs to be connected (see chapter 5.4 Connect).
5.4 Connect
5.4.1 Connecting pneumatics
ATTENTION
The pneumatic connection must be sound so that no leaks occur.
The following requirements apply to pneumatic connections:
They must comply with chapter 3.3 General Connections.
They must be flexible (see chapter 2.4.3 Mechanics).
They must be suitable for vacuum application.
The hose dimensions must be the correct size and the pumping capacity must not be
impaired.
Select the shortest connection length possible.
24
Operating Manual MXPC 303 Z/603 T