Advertisement
III
▪ Lower the pressure arm so as to raise the roller retainer to feed
wire through the drive roll.
V
▪ While turning the wire reel counter-clockwise, pass the end of
the wire through the guide tube.
▪ Guide the wire to the correct roller groove
Push it through to the inlet tube of the torch.
NOTE:
comes off the spool, it will look like the illustration above. The
wire should unspool from the bottom, and the spool will
rotate in a counter-clockwise manner.
.
▪ Wire from reel to the drive should relax with a slight curve after
feeding, it should not be a tight-line.
▪ Place the retainer back and Pull up the pressure arm back to
position and turn the knob clockwise.
The placement of the reel should be such that the wire
IV
VI
(according to its size)
12
IBL M200-105
Advertisement
