Safe Connecting Instructions; Work Top (Optional) - Hansen S3000 Manual

9 Safe connecting instructions of regulators to cylinders
● Before connecting the LPG regulator to the gas cylinder
ensure that the rubber seal on the end of the regulator
is in place and is in good condition.
● The cylinder valve thread is a left hand thread and the
regulator hand wheel must be turner in an anticlockwise
direction (when facing the cylinder thread opening) to
engage the regulator thread into the cylinder valve.
● Always make sure the the regulator is fully engaged
with the cylinder valve threads and that the hand wheel
is tight. Hand tighten only. Do not use excessive force.
● When connecting the cylinder always check for leaks by
opening the cylinder valve and then apply soapy water
solution to the joint between the cylinder valve and the
regulator.
● If you find a leak, close the cylinder valve and contact an
authorised LP Gas dealer.
● When using the appliance, do not fully open the cylinder
valve. Only open it 1 ½
jamming of the cylinder valve in its open position.
● NEVER UNSCREW THE REGULATOR FROM THE
CYLINDER VALVE WHILST THE CYLINDER VALVE IS
OPEN OR IF THE APPLIANCE IS ALIGHT.
1 Work top (Optional)
This warning is clearly shown on the wood chopping board. Ignition of any of the burners must always be done with the
board removed.
cooled down to normal ambient temperature.
Hand wash in warm water and soap. Towel or air dry It's that simple! Our bamboo bowls, utensils and other house wares have a
maintenance free finish, so they clean up easily and require no oiling or conditioning. As with our cutting boards, please do not
soak your bamboo (or any wood) house wares. Prolonged submersion in water can open the natural fibres and cause splitting.
All wood cutting boards benefit from periodic conditioning, so we recommend treating your new board with oil (we can
recommend our Revitalizing Mineral Oil or Coconut oil). Just spread the oil liberally across the surface of your new board, let sit
overnight if possible, then wipe away any remaining oil before use. Repeat this process whenever the board looks dry.
Notes
turns to prevent the possible
! replace the wooden board when the burners are on. Only replace the board after the stove has