1 Explanation of symbols Symbol indicates possible hazard, ignoring this warning could cause serious injury or death. Important pay attention ! Failure to observe this note can cause material damages and effect the operation of the product. Note : Additional information relative to the use of the project 2 General safety instructions The manufacturer does not assume any liability for damages in the following cases : ●...
Once connected , check the gas circuit seal by using a non-corrosive fluid to detect any leaks. 4.3 Fixing The appliance must be fixed to the cabinet using the screws as described in Fig 4. 5 Technical Specifications Model : S3000 Mounting position : Horizontal only Gas type : LPG Gas operating pressure : 2.8 kPa Injector hole size : 0.6 mm...
6.2 Stove Burner The flame must not spread over the edge of the cookware, lace the cookware centrally on the burner, so that it is stable on he support grid. Ignition of the hob Ignition must be done without any cookware or other object on the burners ●...
Hansen products, or the - Non operation of the stove or resultant damage to the caravan / RV / craft in which the Hansen product has been unit where the stove has been operated in an out of level installed, to any authorised service agent.
9 Safe connecting instructions of regulators to cylinders ● Before connecting the LPG regulator to the gas cylinder ensure that the rubber seal on the end of the regulator is in place and is in good condition. ● The cylinder valve thread is a left hand thread and the regulator hand wheel must be turner in an anticlockwise direction (when facing the cylinder thread opening) to engage the regulator thread into the cylinder valve.