Table of Contents
Advertisement
20. If the flat tire was able to
inflate to the
recommended inflation
pressure, remove the
maximum speed label from
the sealant canister and
place it in a highly visible
location.
Do not exceed the speed
on this label until the
damaged tire is repaired or
replaced.
21. Return the equipment to
its original storage location
in the vehicle.
22. Immediately drive the
vehicle 8 km (5 mi) to
distribute the sealant in
the tire.
23. Stop at a safe location and
check the tire pressure.
Refer to Steps 1 10 under
Using the Tire Sealant and
Compressor Kit without
Sealant to Inflate a Tire
(Not Punctured).
If the tire pressure has
fallen more than 68 kPa
(10 psi) below the
recommended inflation
pressure, stop driving the
vehicle. The tire is too
severely damaged and the
tire sealant cannot seal the
tire. See Roadside
Assistance Program 0 439.
If the tire pressure has not
dropped more than 68 kPa
(10 psi) from the
recommended inflation
pressure, inflate the tire to
the recommended inflation
pressure.
Vehicle Care
24. Wipe off any sealant from
the wheel, tire, or vehicle.
25. Dispose of the used tire
sealant canister (4) at a
local dealer or in
accordance with local
state codes and practices.
26. Replace it with a new
canister available from
your dealer.
27. After temporarily sealing a
tire using the tire sealant
and compressor kit, take
the vehicle to an
authorized dealer within
161 km (100 mi) of driving
to have the tire repaired or
replaced.
395
Advertisement
Chapters
Table of Contents
