Related Manuals for TQC Sheen PowderTAG
Summary of Contents for TQC Sheen PowderTAG
- Page 1 IMPORTANT! Before taking this instrument in use we strongly advise you to read this manual carefully. PowderTAG LD5860 Thickness Analysing Gauge Operating Instructions (V1.4 0718)
-
Page 2: Warranty
WARRANTY TQC Sheen will grant a warranty for a period of 12 months for the PowderTAG and 12 months for all related equipment from the date of delivery in respect of any evidence of faulty workmanship and materials. Should a delivered consignment prove to be... - Page 3 Scope of supply 11.3 Cleaning Technical data 11.4 Batteries Power supply 11.5 Precautions - batteries in carry-on baggage (aircraft cabin). Instrument controls and functions Disclaimer Do’s and don’ts Getting started Insert batteries and connect sensor Starting the PowderTAG and perform measurements...
-
Page 4: Safety Instructions
1.2 Safety connected to the display device with a cable. use. TQC Sheen will not be held liable for damage injury. All warnings must be read and observed in order resulting from improper use. Designated purpose... -
Page 5: Transport And Storage
The batteries should not • Store instrument in the original packing if possible. be charged close to combustible materials! to TQC Sheen. • Avoid external sources of heat such as sun, heaters and fire. There is a risk of explosion. -
Page 6: Instrument Data
50 - 300 microns * Depending on the material properties 4.4 Power supply The PowderTAG is powered by four Li-Ion batteries 3.7V type (included). It is not suitable for operation with conventional 1.5V AA batteries. To charge the batteries, an external battery charger... -
Page 7: Do's And Don'ts
PowderTAG values against a regular coating thickness gauge. • When a second layer of coating is applied the PowderTAG will add 25% of the layer thickness of the first (cured) layer to the measured value of the second layer. To calculate the actual layer thickness of the second layer this 25% has to be substracted from the measured value. -
Page 8: Getting Started
7 GETTING STARTED 8 USER INTERFACE 7.2 Starting the PowderTAG and perform This chapter is intended for first-time users of the The measuring equipment will switch automatically You read the current calibration used and the measurements instrument. It is a quick introduction to the use to the menu for measurement operation. - Page 9 • Use the arrow button to change or confirm with even after changing batteries, the instrument Powder: the OK button. needs to be returned to TQC Sheen. Measures the expected dry film thickness after cure Max deviation • Compliance with or under-/overshoot of activated...
-
Page 10: Measuring Mode
After confirming Powder and single-point E.G.: the first layer (cured) is 100 µm. The PowderTAG measurement area. This is particularly important calibration, you end up in the measured value recor- measures 85 µm on the second layer. - Page 11 + - offset. The confirm the final value. use calibration objects which layer thicknesses are is 60µm. On this same area the PowderTAG new offset is automatically stored when you touch at the outer limits of the expected measuring range measured a mean of 53µm.
-
Page 12: Care And Maintenance
- Relative humidity: max. 80%, at temperatures of The battery employed in PowderTAG is a generic of the product. The information contained in this 32 °C max. 50%See also section 11.5 Batteries in single cell Lithium-Ion battery, 3.7V 850mAh. - Page 13 www.tqcsheen.com...
Need help?
Do you have a question about the PowderTAG and is the answer not in the manual?
Questions and answers