Classic Accessories WAVEGEAR EXTREME Personal Watercraft Cover Instructions

instructions:
WARNING
When transporting your P.W.C. on a
trailer or an open vehicle be sure to
use and tighten all the straps—the
cover could blow off and cause
injury to others.
CAUTION
Failure to use and tighten all the
straps when transporting your
P.W.C. on a trailer or an
open vehicle can cause damage to
your cover or vehicle.

insTallaTion

1. Cover any sharp points with
cloth or a sponge to avoid
stressing or tearing your cover.
2. Drape your cover over your
personal watercraft (P.W.C.) with
the tapered end marked "FRONT"
at the bow.
3. Pull your cover below the rub
rail around your entire P.W.C.
4. Tie one end of the supplied
nylon rope to a side D-ring sewn
into the bottom hem of the
cover. Pull the rope under the
watercraft to the corresponding
D-ring on the opposite side.
Allowing enough rope to make a
knot, cut off the rope and tie into
the second D-ring. Repeat with
remaining D-rings.
5. Carefully singe the ends of the
rope with a match or lighter to
prevent fraying of the ends.
6. Adjust and tighten cover as
necessary for your watercraft.
20-034-031001-00, 20-035-041001-00, 20-034-031001-EC, 20-035-041001-EC, 20-034-031001-CT, 20-035-041001-CT
Personal Watercraft Cover

Trailering

To use your Classic WaveGear
Personal Watercraft Cover when
trailering you MUST use the
trailering strap. Trailering without it
will invalidate your warranty.
1. Be sure that you have installed
your cover tightly and that all
ropes are firmly attached.
2. Tie a rope to the bow D-ring
on the cover and cinch tight to
the trailer or pull the cover down
over your watercraft's trailer
attachment ring.
3. Sewn along the top of your
cover you will find webbing loops.
Thread the trailering strap under the
webbing loop that will best provide
the clearance to cinch your cover
down toward the seat behind the
steering column. Run the strap
under the watercraft, thread the
strap into it's buckle and tighten
the strap to secure your cover. Be
sure that there are no loose areas
that can flap in the wind while you
drive.
4. After driving a mile, recheck all
straps, adjusting as necessary for
®
a tight fit.

Care and Cleaning

If your watercraft cover becomes
dirty, it can be cleaned with
lukewarm water and a soft brush.
DO NOT USE SOAP, or clean in
washing machine - it can damage
the protective coatings on your cover.

sTorage

To avoid mildew be sure your cover
is completely dry before you store
it for any extended period in its
attached stuff sack.
CLASSIC ACCESSORIES, INC.
KENT, WA USA 98032 © 2 0 1 3
c l a s s i c a c c e s s o r i e s . c o m
10cOW55_11360