Instructions:
WARNING
When transporting your PWC on a
trailer or an open vehicle be sure to
use and tighten all the straps—the
cover could blow off and cause
injury to others.
CAUTION
Failure to use and tighten all the
straps when transporting your
PWC on a trailer or an open vehicle
can cause damage to your cover or
vehicle.
Installation
1. Cover any sharp points with cloth
or a sponge to avoid stressing or
tearing your cover.
2. Drape your cover over your
personal watercraft (PWC) with the
tapered end marked "FRONT" at
the bow.
3. Pull your cover below the rub rail
around your entire PWC
4. Your cover includes three straps
that secure your cover to your PWC
(These must be used if you are
transporting your PWC on a trailer).
Locate a strap attached to the
bottom of a triangular tension panel
along the hem. Run this strap under
your PWC to the corresponding
buckle on the other side, clip it into
that buckle and tighten as needed.
Repeat with the other two straps.
Stellex
Personal Watercraft Cover
™
5. After attaching ALL three straps
adjust and tighten all the straps so
that your cover is snug and even
across your PWC. Roll up any extra
length of strap hanging below the
buckle and secure it with the rip-and-
grip strap keeper at the end of the
strap. This will keep the strap from
flapping in the wind during trailer
transport. For additional security
tuck the extra strap and strap keeper
under the cover.
Access Doors
You can access
your gas tank on
some models
without removing
the cover via
zippered access
doors on both
sides of your cover.
Trailering
To use your cover when transporting
your PWC on a trailer you MUST use
all the trailering straps.
Before driving check that all straps
are tight and firmly attached, that the
strap ends are secured by the strap
keepers and that the access doors
on the cover are zipped shut. After
driving the first mile, it's a good idea
to recheck your cover.
Care and Cleaning
If your cover becomes dirty it can
be cleaned with luke-warm water
and a soft brush. DO NOT USE
SOAP OR DETERGENT as it may
damage the protective coatings on
your cover. Line dry.
Storage
To avoid mildew be sure your cover is
completely dry before you store it for
any extended period in its attached
stuff sack.
CLASSIC ACCESSORIES, INC.
22640 68th AVENUE SOUTH
KENT, WA USA 98032 © 2 0 1 5
c l a s s i c a c c e s s o r i e s . c o m
20-208-030501-00, 20-209-040501-00,
20-208-030501-MFF, 20-209-040501-MFF
15cB54_18677
Need help?
Do you have a question about the Stellex and is the answer not in the manual?
Questions and answers