Page 1
Thank you for purchasing our appliance. Please be sure to read the entirety of this user manual carefully prior to using this appliance. If you have any questions regarding the use of this product, please call 1 (800) 898-3002.
TABLE OF CONTENTS Important Safety Instructions ....6 Installation ..........9 Operating Instructions......12 Cleaning and Maintenance ....16 Troubleshooting ........17 Warranty ............ 19 Manufacturing Info ......... 19 Warning ............. 19 Contact Us ..........19...
Page 4
Failure to keep the product in its original quality from the time of receipt may impede hOme™’s ability to correct any legitimate problem and may limit the extent to...
Page 5
Congratulations on bringing home your new appliance! Don’t forget to register your product at homelabs.com/reg for updates, coupons, and other relevant information. Although greatly appreciated, product registration is not required to activate any warranty.
Important Safety Instructions • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. •...
Page 7
Important Safety Instructions This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Page 8
The capacity of the air to hold water vapor increases with temperature. This is why in our home, as soon as the temperature decreases, the vapor contained in the air condenses, as is evident on the colder surfaces in the room, such as the windows, walls etc. The purpose of a dehumidifier is to remove the excess moisture from the air, avoiding the damage caused by condensation.
Installation Note: All the illustrations in this manual are for explanatory purposes only. Your appliance may be slightly different. Component Description 1. Control panel 2. Air outlet 3. Bucket 4. Water level view window 5. Casters 6. Handle 7. Air intake filter 8.
Page 10
Installation Take out accessories from bucket The accessories are stored in the bucket during transportation. Before use, remove the accessories from the bucket. - Remove the bucket from the unit. - Rotate the handle to the position like below figure and remove the handle. - Open the bucket cover and take out the power plug and other accessories.
Page 11
Installation Use the hooking strip When you use dehumidifier, open the hooking strip at the back of the dehumidifier to tie up the power cord. When you do not use the dehumidifier, power cord can also be tied up by hooking strip again and fasten into the hole.
Operating Instructions CONTROL PANEL 4 5 6 7 Timer Cont. Clean Turbo Pump Lock Full FILTER TURBO INCREASE PUMP DECREASE TIMER POWER 1. Clean Filter indicator A. On/Off button 2. Turbo indicator B. Timer button 3. Display screen C. Decrease button 4.
Page 13
Operating Instructions Timer button This timer can be used to delay the appliance start-up or shutdown, this avoids wasting electricity by optimizing operating periods. • Programming start-up 1. Turn on the appliance, choose the mode you want, for example Dehumidify mode, high fan speed. Turn off the appliance.
Page 14
Operating Instructions Note: • Hold the bucket with both hands when emptying the bucket. • The unit will not run again until the bucket is emptied and properly placed back inside the unit. • When the bucket is full or removed from the unit, the compressor will turn off but the fan will continue to run for a few minutes.
Page 15
Operating Instructions Pump drain The max. height of pump drainage is about 16.4 feet. Take below steps to start the Pump drain. 1. Connect the pump 16.4 feet drain pipe to the back of the unit. 2. Put the unit on level floor. Unscrew the cap on the back of the unit. 3.
Cleaning and Maintenance Before any cleaning or maintenance, turn off the appliance and unplug it from the wall socket. • Wipe the cabinet of the unit with a slightly damp cloth and then dry it naturally or wipe it dry. •...
Troubleshooting Occasionally, you may encounter some problems that are of a minor nature and a service call may not be necessary. Use this troubleshooting guide to identify possible problems you may be experiencing. Problem Possible Causes Solutions Dehumidifier The dehumidifier is unplugged. Make sure the dehumidifier's plug is pushed does not start.
Page 18
Troubleshooting If the following error code appears, contact the after-sales service department for inspection and repair. Description Code Possible Causes Solutions Humidity sensor Humidity sensor is damaged. Contact customer service center. failure Temperature Temperature sensor is damaged. Contact customer service center. sensor failure Gas leakage Ambient temperature is too high.
These are our general terms for warranty service, but we always urge our customers to reach out to us with any issue, regardless of warranty terms. If you have an issue with a hOme™ product, please contact us at 1 (800) 898-3002, and we will do our best to resolve it for you.
Need help?
Do you have a question about the HME020279N and is the answer not in the manual?
Questions and answers