Page 2
Defective product should be clearly marked or stored where it cannot be used again by mistake. Failure to retain the product may impede hOme ™ ’s ability to correct any legitimate problem ™ and may limit the extent to which hOme may provide recourse.
TABLE OF CONTENTS Important Safety Instructions Installation Operation 8-11 Cleaning and Maintenance Specification Troubleshooting Warranty Manufacturing Info Warning Contact Us...
Page 5
Congratulations on bringing home your new appliance! Don’t forget to register your product at homelabs.com/reg for updates, coupons, and other relevant information. Although greatly appreciated, product registration is not required to activate any warranty.
Important Safety Instructions WARNING When using this product, follow below basic precautions to reduce the risk of fire or electric shock. All refrigeration products contain refrigerants, which under federal law must be removed prior to disposal. • This instruction manual is an integral part of the appliance and should be stored for future reference. It must accompany the unit in event of ownership transfer or for reference by a service engineer.
Installation Attach the handle As the figure shows, attach the handle to the appliance and tighten the screws securely. Install the drain hose Attach the supplied drain hose to the draining nozzle on the appliance. Direct the hose to the desired area before operating the appliance.
Operation PARTS DESCRIPTION Handle Control panel Air inlet Wheel Universal castors Air outlet Power cord hooks Built-in handle Drainage port Radiator grille...
Page 9
Operation more than 11.8 in (30cm) PLACE THE APPLIANCE - This unit may have been tilted or placed upside down during shipping. To ensure this device works properly, please ensure this unit is upright for at least 24 hours before initial use. more than 11.8 in (30cm) more than 11.8 in (30cm) - This dehumidifier is designed...
Page 10
Operation To set the humidity level The default set humidity level is 50%RH. To increase or decrease the humidity level, press and hold DECREASE or INCREASE button. The humidity level can be increased or decreased by increments of 5%RH in normal mode. Note: Environmental humidity and appliance set humidity will decide the status of the compressor and fan as follow:...
Page 11
Operation Error codes In case of malfunction, the appliance will display an error code. E1 - Temperature sensor fails. The system will work in cycles of dehumidification for 30 minutes and defrosting for 15 minutes. The temperature sensor needs to be replaced. Please call customer service for further support.
Cleaning and maintenance • Clean the appliance with a soft wet cloth. • Remove the filter out of the unit. • Pull the louver on the front panel out to • Use a clean rag to adsorb the surface dust gain access to the filter.
Troubleshooting PROBLEM CAUSE SOLUTION • Make sure the dehumidifier’s plug • The dehumidifier is not plugged is inserted completely into the well. outlet. • The house fuse blows or the • Replace with a new fuse or reduce The appliance does circuit breaker trips.
(“warranty period”) on all of our products purchased new and unused from hOme Technologies, LLC or an authorized reseller, with an original proof of purchase and where a defect has arisen, wholly or substantially, as a result of faulty manufacture, parts or workmanship during the warranty period.
Need help?
Do you have a question about the HME020437N and is the answer not in the manual?
Questions and answers